The A-MPDU TX retransmission rate is always high (> 20%) even in a very
clean environment. However, the vendor driver retransimission rate is
< 10% in the same test bed. The difference is the vendor driver starts
the A-MPDU TXOP with initial RTS/CTS handshake which is observed in the
air capture and the TX descriptor. Since the driver does not know how
many frames will be aggregated and the estimated duration, forcing the
RTS/CTS protection for A-MPDU helps to lower the retransmission rate
from > 20% to ~12% in the same test setup with the vendor driver.
Signed-off-by: Chris Chiu <chris.chiu@xxxxxxxxxxxxx>
---
v2: revise the commit message to be more explicit.
drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c
index a42e2081b75f..06d59ffb7444 100644
--- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c
+++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c
@@ -4859,7 +4859,7 @@ rtl8xxxu_fill_txdesc_v1(struct ieee80211_hw *hw, struct ieee80211_hdr *hdr,
* rts_rate is zero if RTS/CTS or CTS to SELF are not enabled
*/
tx_desc->txdw4 |= cpu_to_le32(rts_rate << TXDESC32_RTS_RATE_SHIFT);
- if (rate_flags & IEEE80211_TX_RC_USE_RTS_CTS) {
+ if (ampdu_enable || (rate_flags & IEEE80211_TX_RC_USE_RTS_CTS)) {
tx_desc->txdw4 |= cpu_to_le32(TXDESC32_RTS_CTS_ENABLE);
tx_desc->txdw4 |= cpu_to_le32(TXDESC32_HW_RTS_ENABLE);
} else if (rate_flags & IEEE80211_TX_RC_USE_CTS_PROTECT) {
@@ -4930,7 +4930,7 @@ rtl8xxxu_fill_txdesc_v2(struct ieee80211_hw *hw, struct ieee80211_hdr *hdr,
/*
* rts_rate is zero if RTS/CTS or CTS to SELF are not enabled
*/
- if (rate_flags & IEEE80211_TX_RC_USE_RTS_CTS) {
+ if (ampdu_enable || (rate_flags & IEEE80211_TX_RC_USE_RTS_CTS)) {
tx_desc40->txdw3 |= cpu_to_le32(TXDESC40_RTS_CTS_ENABLE);
tx_desc40->txdw3 |= cpu_to_le32(TXDESC40_HW_RTS_ENABLE);
} else if (rate_flags & IEEE80211_TX_RC_USE_CTS_PROTECT) {
--
2.25.1
