The USE_SPI_DMA macro name suggests that it could be set to 1 to control whether or not SPI DMA should be used. However, that's not what it does. If set to 1, it'll set the SPI messages' "is_dma_mapped" flag to true, even though the tx/rx buffers aren't actually DMA mapped by the driver. In other words, setting this flag to 1 will break the driver. Best to clean up this confusion by removing the macro altogether. There is no need to explicitly initialize "is_dma_mapped" because the message is cleared to zero anyhow, so "is_dma_mapped" is set to false by default. Signed-off-by: David Mosberger-Tang <davidm@xxxxxxxxxx> --- drivers/net/wireless/microchip/wilc1000/spi.c | 5 ----- 1 file changed, 5 deletions(-) diff --git a/drivers/net/wireless/microchip/wilc1000/spi.c b/drivers/net/wireless/microchip/wilc1000/spi.c index 640850f989dd..1856525b9834 100644 --- a/drivers/net/wireless/microchip/wilc1000/spi.c +++ b/drivers/net/wireless/microchip/wilc1000/spi.c @@ -99,8 +99,6 @@ static int wilc_spi_reset(struct wilc *wilc); #define DATA_PKT_LOG_SZ DATA_PKT_LOG_SZ_MAX #define DATA_PKT_SZ (1 << DATA_PKT_LOG_SZ) -#define USE_SPI_DMA 0 - #define WILC_SPI_COMMAND_STAT_SUCCESS 0 #define WILC_GET_RESP_HDR_START(h) (((h) >> 4) & 0xf) @@ -240,7 +238,6 @@ static int wilc_spi_tx(struct wilc *wilc, u8 *b, u32 len) memset(&msg, 0, sizeof(msg)); spi_message_init(&msg); msg.spi = spi; - msg.is_dma_mapped = USE_SPI_DMA; spi_message_add_tail(&tr, &msg); ret = spi_sync(spi, &msg); @@ -284,7 +281,6 @@ static int wilc_spi_rx(struct wilc *wilc, u8 *rb, u32 rlen) memset(&msg, 0, sizeof(msg)); spi_message_init(&msg); msg.spi = spi; - msg.is_dma_mapped = USE_SPI_DMA; spi_message_add_tail(&tr, &msg); ret = spi_sync(spi, &msg); @@ -323,7 +319,6 @@ static int wilc_spi_tx_rx(struct wilc *wilc, u8 *wb, u8 *rb, u32 rlen) memset(&msg, 0, sizeof(msg)); spi_message_init(&msg); msg.spi = spi; - msg.is_dma_mapped = USE_SPI_DMA; spi_message_add_tail(&tr, &msg); ret = spi_sync(spi, &msg); -- 2.25.1
