Search Linux Wireless

Re: [PATCH 04/11] mt76: mt7915: use nss for calculating rx-chains

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 12/3/21 1:16 AM, Felix Fietkau wrote:
On 2021-11-18 17:40, greearb@xxxxxxxxxxxxxxx wrote:
From: Ben Greear <greearb@xxxxxxxxxxxxxxx>

When group-5 is enabled, we can find the actuall NSS used.
In that case, update the rx chains info so that the upper
stack can give better idea of actual antenna usage.

Signed-off-by: Ben Greear <greearb@xxxxxxxxxxxxxxx>
I'm not sure this is correct. From my understanding, nss does not determine which antennas (and how many of them) are involved in receiving the signal.

- Felix


I guess this would take some special knowledge of this chip and how firmware reports
the descriptor to know for sure.

Ath10k at least acts similar to how I wrote this patch....

Thanks,
Ben

--
Ben Greear <greearb@xxxxxxxxxxxxxxx>
Candela Technologies Inc  http://www.candelatech.com



[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Wireless Regulations]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux