From: Seevalamuthu Mariappan <seevalam@xxxxxxxxxxxxxx>
Firmware blocks all data traffic until the key is plumbed. But, with
software encryption mode, key is never plumbed to firmware. Due to this,
a traffic failure in software encryption mode has been observed. Hence,
firmware has introduced a flag to differentiate software encryption
mode. This flag can be passed during vdev_start command.
Enable WMI_VDEV_START_HW_ENCRYPTION_DISABLED flag in vdev_start command
to notify firmware to disable hardware encryption for a vdev. This is set
if raw mode software encryption is enabled.
Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.4.0.1-01421-QCAHKSWPL_SILICONZ-1
Signed-off-by: Seevalamuthu Mariappan <seevalam@xxxxxxxxxxxxxx>
Signed-off-by: Jouni Malinen <jouni@xxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath11k/wmi.c | 2 ++
drivers/net/wireless/ath/ath11k/wmi.h | 1 +
2 files changed, 3 insertions(+)
diff --git a/drivers/net/wireless/ath/ath11k/wmi.c b/drivers/net/wireless/ath/ath11k/wmi.c
index 43344e774a31..020b2b7ee3c8 100644
--- a/drivers/net/wireless/ath/ath11k/wmi.c
+++ b/drivers/net/wireless/ath/ath11k/wmi.c
@@ -884,6 +884,8 @@ int ath11k_wmi_vdev_start(struct ath11k *ar, struct wmi_vdev_start_req_arg *arg,
}
cmd->flags |= WMI_VDEV_START_LDPC_RX_ENABLED;
+ if (test_bit(ATH11K_FLAG_HW_CRYPTO_DISABLED, &ar->ab->dev_flags))
+ cmd->flags |= WMI_VDEV_START_HW_ENCRYPTION_DISABLED;
ptr = skb->data + sizeof(*cmd);
chan = ptr;
diff --git a/drivers/net/wireless/ath/ath11k/wmi.h b/drivers/net/wireless/ath/ath11k/wmi.h
index 1fff74b2b476..16b3f48bb378 100644
--- a/drivers/net/wireless/ath/ath11k/wmi.h
+++ b/drivers/net/wireless/ath/ath11k/wmi.h
@@ -2577,6 +2577,7 @@ struct wmi_vdev_down_cmd {
#define WMI_VDEV_START_HIDDEN_SSID BIT(0)
#define WMI_VDEV_START_PMF_ENABLED BIT(1)
#define WMI_VDEV_START_LDPC_RX_ENABLED BIT(3)
+#define WMI_VDEV_START_HW_ENCRYPTION_DISABLED BIT(4)
struct wmi_ssid {
u32 ssid_len;
--
2.25.1
