From: Chris Chiu <chris.chiu@xxxxxxxxxxxxx> There will be crazy numbers of interrupts triggered by 8188cu and 8192cu module, around 8000~10000 interrupts per second, on the usb host controller. Compare with the vendor driver source code, it's mapping to the configuration CONFIG_USB_INTERRUPT_IN_PIPE and it is disabled by default. Since the interrupt transfer is neither used for TX/RX nor H2C commands. Disable it to avoid the confusing interrupts for the 8188cu and 8192cu module which I only have for verification. Signed-off-by: Chris Chiu <chris.chiu@xxxxxxxxxxxxx> --- drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c index 03c6ed7efe06..6a3dfa71b27f 100644 --- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c +++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c @@ -1670,7 +1670,7 @@ static int rtl8xxxu_identify_chip(struct rtl8xxxu_priv *priv) priv->rf_paths = 2; priv->rx_paths = 2; priv->tx_paths = 2; - priv->usb_interrupts = 1; + priv->usb_interrupts = 0; priv->rtl_chip = RTL8192C; } priv->has_wifi = 1; @@ -1680,7 +1680,7 @@ static int rtl8xxxu_identify_chip(struct rtl8xxxu_priv *priv) priv->rx_paths = 1; priv->tx_paths = 1; priv->rtl_chip = RTL8188C; - priv->usb_interrupts = 1; + priv->usb_interrupts = 0; priv->has_wifi = 1; } -- 2.20.1