On Wed, 2021-03-31 at 05:03 -0700, Ben Greear wrote: > On 3/31/21 2:14 AM, Luca Coelho wrote: > > From: Ilan Peer <ilan.peer@xxxxxxxxx> > > > > When doing scan while 6GHz channels are not enabled, the 6GHz band > > is not scanned. Thus, if there are no APs on the 2GHz and 5GHz bands > > (that will allow discovery of geographic location etc. that would > > allow enabling the 6GHz channels) but there are non collocated APs > > on 6GHz PSC channels these would never be discovered. > > > > To overcome this, FW added support for performing passive UHB scan > > in case no APs were discovered during scan on the 2GHz and 5GHz > > channels. > > > > Add support for enabling such scan when the following conditions are > > met: > > > > - 6GHz channels are supported but not enabled by regulatory. > > - Station interface is not associated or less than a defined time > > interval passed from the last resume or HW reset flows. > > - At least 4 channels are included in the scan request > > - The scan request includes the widlcard SSID. > > - At least 50 minutes passed from the last 6GHz passive scan. > > Why are you trying so hard to not do passive scans? This seems like it > is set up for all sorts of frustration. This is because of regulatory restrictions. Maybe Ilan can clarify more. -- Cheers, Luca.
