Anilkumar Kolli <akolli@xxxxxxxxxxxxxx> writes:
> QCN9074 is PCI based 11ax radio.
> - has 2G/5G/6G variants.
> - has NSS 2x2 and 4x4 variants.
>
> QCN9074 uses 45MB of HOST DDR memory, target requests host memory in
> segments, each segment is of 2MB size and is physcial contiguous and
> use static window configuration.
>
> Below QMI issues are seen with QCN9074,
> Issue 1:
> ath11k_pci 0000:06:00.0: qmi failed memory request, err = -110
> ath11k_pci 0000:06:00.0: qmi failed to respond fw mem req:-110
> Issue 2:
> ath11k_pci 0000:06:00.0: firmware crashed: MHI_CB_SYS_ERROR
> ath11k_pci 0000:06:00.0: qmi failed set mode request, mode: 0, err = -110
> ath11k_pci 0000:06:00.0: qmi failed to send wlan fw mode:-110
I clarified the commit log to mention that QCN9074 is not fully working
yet.
> Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.4.0.1.r2-00012-QCAHKSWPL_SILICONZ-1
>
> Signed-off-by: Anilkumar Kolli <akolli@xxxxxxxxxxxxxx>
> ---
> drivers/net/wireless/ath/ath11k/pci.c | 20 ++++++++++++++++++--
> 1 file changed, 18 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/net/wireless/ath/ath11k/pci.c b/drivers/net/wireless/ath/ath11k/pci.c
> index 70dcb80475b1..259a39e59a91 100644
> --- a/drivers/net/wireless/ath/ath11k/pci.c
> +++ b/drivers/net/wireless/ath/ath11k/pci.c
> @@ -34,10 +34,12 @@
> */
> #define ACCESS_ALWAYS_OFF 0xFE0
>
> -#define QCA6390_DEVICE_ID 0x1101
> +#define QCA6390_DEVICE_ID 0x1101
Here you convert tabs to spaces, I fixed them back.
> +#define QCN9074_DEVICE_ID 0x1104
And modified this to use tabs as well.
> static const struct pci_device_id ath11k_pci_id_table[] = {
> { PCI_VDEVICE(QCOM, QCA6390_DEVICE_ID) },
> + { PCI_VDEVICE(QCOM, QCN9074_DEVICE_ID) },
I removed this and added a comment instead. Let's add the pci id once
the device is fully working.
--
https://patchwork.kernel.org/project/linux-wireless/list/
https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
