Ryder Lee <ryder.lee@xxxxxxxxxxxx> writes: > On Wed, 2021-01-06 at 16:41 +0100, Toke Høiland-Jørgensen wrote: >> Felix Fietkau <nbd@xxxxxxxx> writes: >> >> > On 2021-01-06 11:51, Toke Høiland-Jørgensen wrote: >> >> Ryder Lee <ryder.lee@xxxxxxxxxxxx> writes: >> >> >> >>> The selected txq should be scheduled unconditionally if >> >>> NL80211_EXT_FEATURE_AIRTIME_FAIRNESS is not set by driver. >> >>> >> >>> Also put the sta to the end of the active_txqs list if >> >>> deficit is negative then move on to the next txq. >> >> >> >> Why is this needed? If the feature is not set, no airtime should ever be >> >> accounted to the station, and so sta->airtime[txqi->txq.ac].deficit will >> >> always be 0 - so you're just adding another check that doesn't actually >> >> change the behaviour, aren't you? >> > >> > I think it might make sense to keep airtime reporting even when airtime >> > fairness is disabled at run time, so this patch makes sense to me. >> > Instead of this patch, the right place to deal with this would probably >> > be ieee80211_sta_register_airtime. >> >> When the fairness mechanism is user-disabled I agree it makes sense to >> still keep the accounting; and in fact that's what >> ieee80211_sta_register_airtime() already does when the accounting is >> turned off by way of the airtime_flags field... So don't think anything >> else is needed there either? >> >> -Toke > > Not sure I get this right. Are you talking about local->airtime_flags = > AIRTIME_USE_TX | AIRTIME_USE_RX ? I think that's different and we still > need to take NL80211_EXT_FEATURE_AIRTIME_FAIRNESS into account, right? I just meant that what Felix was asking for (a way *for the user* to disable airtime fairness while still getting the airtime usage accounted) is possible by setting those flags. The EXT_FEATURE flag is meant as a way for the driver to signal to mac80211 that it supports reporting airtime at all; so ideally it should be a flag that is only set once. Going back and reading your initial response it seems like you may be toggling the flag dynamically in the driver, though? Is this accurate? And if so, why? Is it not enough for you to fiddle with the USE_TX/USE_RX flags? :) -Toke
