Search Linux Wireless

[PATCH] mac80211: 160Mhz with extended NSS BW in CSA

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Upon receiving CSA with 160Mhz extended NSS BW from associated AP,
STA should set the HT operation_mode based on new_center_freq_seg1
because it is later used as ccfs2 in ieee80211_chandef_vht_oper().

Signed-off-by: Aviad Brikman <aviad.brikman@xxxxxxxxxx>
Signed-off-by: Shay Bar <shay.bar@xxxxxxxxxx>
---
 net/mac80211/spectmgmt.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/net/mac80211/spectmgmt.c b/net/mac80211/spectmgmt.c
index ae1cb2c68722..c235ddceb835 100644
--- a/net/mac80211/spectmgmt.c
+++ b/net/mac80211/spectmgmt.c
@@ -133,16 +133,19 @@ int ieee80211_parse_ch_switch_ie(struct ieee80211_sub_if_data *sdata,
 	}
 
 	if (wide_bw_chansw_ie) {
+		u8 new_seg1 = wide_bw_chansw_ie->new_center_freq_seg1;
 		struct ieee80211_vht_operation vht_oper = {
 			.chan_width =
 				wide_bw_chansw_ie->new_channel_width,
 			.center_freq_seg0_idx =
 				wide_bw_chansw_ie->new_center_freq_seg0,
-			.center_freq_seg1_idx =
-				wide_bw_chansw_ie->new_center_freq_seg1,
+			.center_freq_seg1_idx = new_seg1,
 			/* .basic_mcs_set doesn't matter */
 		};
-		struct ieee80211_ht_operation ht_oper = {};
+		struct ieee80211_ht_operation ht_oper = {
+			.operation_mode = (le16_to_cpu(new_seg1) <<
+					   IEEE80211_HT_OP_MODE_CCFS2_SHIFT),
+		};
 
 		/* default, for the case of IEEE80211_VHT_CHANWIDTH_USE_HT,
 		 * to the previously parsed chandef
-- 
2.17.1




[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Wireless Regulations]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux