On Tue, 2020-11-10 at 18:51 +0000, Kalle Valo wrote:
> Tsuchiya Yuto <kitakar@xxxxxxxxx> wrote:
>
> > If a reset is performed, but even the reset fails for some reasons (e.g.,
> > on Surface devices, the fw reset requires another quirks),
> > cancel_work_sync() hangs in mwifiex_cleanup_pcie().
> >
> > # firmware went into a bad state
> > [...]
> > [ 1608.281690] mwifiex_pcie 0000:03:00.0: info: shutdown mwifiex...
> > [ 1608.282724] mwifiex_pcie 0000:03:00.0: rx_pending=0, tx_pending=1, cmd_pending=0
> > [ 1608.292400] mwifiex_pcie 0000:03:00.0: PREP_CMD: card is removed
> > [ 1608.292405] mwifiex_pcie 0000:03:00.0: PREP_CMD: card is removed
> > # reset performed after firmware went into a bad state
> > [ 1609.394320] mwifiex_pcie 0000:03:00.0: WLAN FW already running! Skip FW dnld
> > [ 1609.394335] mwifiex_pcie 0000:03:00.0: WLAN FW is active
> > # but even the reset failed
> > [ 1619.499049] mwifiex_pcie 0000:03:00.0: mwifiex_cmd_timeout_func: Timeout cmd id = 0xfa, act = 0xe000
> > [ 1619.499094] mwifiex_pcie 0000:03:00.0: num_data_h2c_failure = 0
> > [ 1619.499103] mwifiex_pcie 0000:03:00.0: num_cmd_h2c_failure = 0
> > [ 1619.499110] mwifiex_pcie 0000:03:00.0: is_cmd_timedout = 1
> > [ 1619.499117] mwifiex_pcie 0000:03:00.0: num_tx_timeout = 0
> > [ 1619.499124] mwifiex_pcie 0000:03:00.0: last_cmd_index = 0
> > [ 1619.499133] mwifiex_pcie 0000:03:00.0: last_cmd_id: fa 00 07 01 07 01 07 01 07 01
> > [ 1619.499140] mwifiex_pcie 0000:03:00.0: last_cmd_act: 00 e0 00 00 00 00 00 00 00 00
> > [ 1619.499147] mwifiex_pcie 0000:03:00.0: last_cmd_resp_index = 3
> > [ 1619.499155] mwifiex_pcie 0000:03:00.0: last_cmd_resp_id: 07 81 07 81 07 81 07 81 07 81
> > [ 1619.499162] mwifiex_pcie 0000:03:00.0: last_event_index = 2
> > [ 1619.499169] mwifiex_pcie 0000:03:00.0: last_event: 58 00 58 00 58 00 58 00 58 00
> > [ 1619.499177] mwifiex_pcie 0000:03:00.0: data_sent=0 cmd_sent=1
> > [ 1619.499185] mwifiex_pcie 0000:03:00.0: ps_mode=0 ps_state=0
> > [ 1619.499215] mwifiex_pcie 0000:03:00.0: info: _mwifiex_fw_dpc: unregister device
> > # mwifiex_pcie_work hang happening
> > [ 1823.233923] INFO: task kworker/3:1:44 blocked for more than 122 seconds.
> > [ 1823.233932] Tainted: G WC OE 5.10.0-rc1-1-mainline #1
> > [ 1823.233935] "echo 0 > /proc/sys/kernel/hung_task_timeout_secs" disables this message.
> > [ 1823.233940] task:kworker/3:1 state:D stack: 0 pid: 44 ppid: 2 flags:0x00004000
> > [ 1823.233960] Workqueue: events mwifiex_pcie_work [mwifiex_pcie]
> > [ 1823.233965] Call Trace:
> > [ 1823.233981] __schedule+0x292/0x820
> > [ 1823.233990] schedule+0x45/0xe0
> > [ 1823.233995] schedule_timeout+0x11c/0x160
> > [ 1823.234003] wait_for_completion+0x9e/0x100
> > [ 1823.234012] __flush_work.isra.0+0x156/0x210
> > [ 1823.234018] ? flush_workqueue_prep_pwqs+0x130/0x130
> > [ 1823.234026] __cancel_work_timer+0x11e/0x1a0
> > [ 1823.234035] mwifiex_cleanup_pcie+0x28/0xd0 [mwifiex_pcie]
> > [ 1823.234049] mwifiex_free_adapter+0x24/0xe0 [mwifiex]
> > [ 1823.234060] _mwifiex_fw_dpc+0x294/0x560 [mwifiex]
> > [ 1823.234074] mwifiex_reinit_sw+0x15d/0x300 [mwifiex]
> > [ 1823.234080] mwifiex_pcie_reset_done+0x50/0x80 [mwifiex_pcie]
> > [ 1823.234087] pci_try_reset_function+0x5c/0x90
> > [ 1823.234094] process_one_work+0x1d6/0x3a0
> > [ 1823.234100] worker_thread+0x4d/0x3d0
> > [ 1823.234107] ? rescuer_thread+0x410/0x410
> > [ 1823.234112] kthread+0x142/0x160
> > [ 1823.234117] ? __kthread_bind_mask+0x60/0x60
> > [ 1823.234124] ret_from_fork+0x22/0x30
> > [...]
> >
> > This is a deadlock caused by calling cancel_work_sync() in
> > mwifiex_cleanup_pcie():
> >
> > - Device resets are done via mwifiex_pcie_card_reset()
> > - which schedules card->work to call mwifiex_pcie_card_reset_work()
> > - which calls pci_try_reset_function().
> > - This leads to mwifiex_pcie_reset_done() be called on the same workqueue,
> > which in turn calls
> > - mwifiex_reinit_sw() and that calls
> > - _mwifiex_fw_dpc().
> >
> > The problem is now that _mwifiex_fw_dpc() calls mwifiex_free_adapter()
> > in case firmware initialization fails. That ends up calling
> > mwifiex_cleanup_pcie().
> >
> > Note that all those calls are still running on the workqueue. So when
> > mwifiex_cleanup_pcie() now calls cancel_work_sync(), it's really waiting
> > on itself to complete, causing a deadlock.
> >
> > This commit fixes the deadlock by skipping cancel_work_sync() on a reset
> > failure path.
> >
> > After this commit, when reset fails, the following output is
> > expected to be shown:
> >
> > kernel: mwifiex_pcie 0000:03:00.0: info: _mwifiex_fw_dpc: unregister device
> > kernel: mwifiex: Failed to bring up adapter: -5
> > kernel: mwifiex_pcie 0000:03:00.0: reinit failed: -5
> >
> > To reproduce this issue, for example, try putting the root port of wifi
> > into D3 (replace "00:1d.3" with your setup).
> >
> > # put into D3 (root port)
> > sudo setpci -v -s 00:1d.3 CAP_PM+4.b=0b
> >
> > Cc: Maximilian Luz <luzmaximilian@xxxxxxxxx>
> > Signed-off-by: Tsuchiya Yuto <kitakar@xxxxxxxxx>
>
> Patch applied to wireless-drivers-next.git, thanks.
>
> 4add4d988f95 mwifiex: pcie: skip cancel_work_sync() on reset failure path
>
Sorry, but is it too late to ask you to change my commit message? I'd
really appreciate it if it's still possible. If it's difficult, please
ignore this.
Even if it's too late, I hope writing the improved one here still helps
someone as long as there is a link to this mail thread in the Link tag.
So, I write the improved one below anyway:
- added the vendor name (Microsoft) of devices where we observed this issue
- fixed some grammatical errors
If a reset is performed but even the reset fails for some reasons (e.g.,
on Microsoft Surface devices, fw reset requires other quirks),
cancel_work_sync() in mwifiex_cleanup_pcie() hangs.
[...]
Thank you.
