From: Carl Huang <cjhuang@xxxxxxxxxxxxxx>
Host sends wmi command to allow hardware enter idle power
save mode in ath11k_mac_op_start function.
hw parameter idle_ps indicates whether idle power save is supported.
Tested-on: QCA6390 hw2.0 PCI WLAN.HST.1.0.1-01740-QCAHSTSWPLZ_V2_TO_X86-1
Signed-off-by: Carl Huang <cjhuang@xxxxxxxxxxxxxx>
Signed-off-by: Kalle Valo <kvalo@xxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath11k/core.c | 3 +++
drivers/net/wireless/ath/ath11k/hw.h | 1 +
drivers/net/wireless/ath/ath11k/mac.c | 9 +++++++++
3 files changed, 13 insertions(+)
diff --git a/drivers/net/wireless/ath/ath11k/core.c b/drivers/net/wireless/ath/ath11k/core.c
index e94d760b21a0..ebd6886a8c18 100644
--- a/drivers/net/wireless/ath/ath11k/core.c
+++ b/drivers/net/wireless/ath/ath11k/core.c
@@ -64,6 +64,7 @@ static const struct ath11k_hw_params ath11k_hw_params[] = {
BIT(NL80211_IFTYPE_MESH_POINT),
.supports_monitor = true,
.supports_shadow_regs = false,
+ .idle_ps = false,
},
{
.hw_rev = ATH11K_HW_IPQ6018_HW10,
@@ -100,6 +101,7 @@ static const struct ath11k_hw_params ath11k_hw_params[] = {
BIT(NL80211_IFTYPE_MESH_POINT),
.supports_monitor = true,
.supports_shadow_regs = false,
+ .idle_ps = false,
},
{
.name = "qca6390 hw2.0",
@@ -135,6 +137,7 @@ static const struct ath11k_hw_params ath11k_hw_params[] = {
BIT(NL80211_IFTYPE_AP),
.supports_monitor = false,
.supports_shadow_regs = true,
+ .idle_ps = true,
},
};
diff --git a/drivers/net/wireless/ath/ath11k/hw.h b/drivers/net/wireless/ath/ath11k/hw.h
index 8e908bcd491e..1dda4257e6d7 100644
--- a/drivers/net/wireless/ath/ath11k/hw.h
+++ b/drivers/net/wireless/ath/ath11k/hw.h
@@ -160,6 +160,7 @@ struct ath11k_hw_params {
u16 interface_modes;
bool supports_monitor;
bool supports_shadow_regs;
+ bool idle_ps;
};
struct ath11k_hw_ops {
diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c
index 76e218e53fe7..d42858d1a578 100644
--- a/drivers/net/wireless/ath/ath11k/mac.c
+++ b/drivers/net/wireless/ath/ath11k/mac.c
@@ -4208,6 +4208,15 @@ static int ath11k_mac_op_start(struct ieee80211_hw *hw)
rcu_assign_pointer(ab->pdevs_active[ar->pdev_idx],
&ab->pdevs[ar->pdev_idx]);
+ /* allow device to enter IMPS */
+ if (ab->hw_params.idle_ps) {
+ ret = ath11k_wmi_pdev_set_param(ar, WMI_PDEV_PARAM_IDLE_PS_CONFIG,
+ 1, pdev->pdev_id);
+ if (ret) {
+ ath11k_err(ab, "failed to enable idle ps: %d\n", ret);
+ goto err;
+ }
+ }
return 0;
err:
--
2.7.4
