From: Sebastian Andrzej Siewior <bigeasy@xxxxxxxxxxxxx> The usage of in_interrupt() in non-core code is phased out. Ideally the information of the calling context should be passed by the callers or the functions be split as appropriate. libertas uses in_interupt() to select the netif_rx*() variant which matches the calling context. The attempt to consolidate the code by passing an arguemnt or by distangling it failed due lack of knowledge about this driver and because the call chains are hard to follow. As a stop gap use netif_rx_any_context() which invokes the correct code path depending on context and confines the in_interrupt() usage to core code. Signed-off-by: Sebastian Andrzej Siewior <bigeasy@xxxxxxxxxxxxx> Signed-off-by: Thomas Gleixner <tglx@xxxxxxxxxxxxx> Acked-by: Kalle Valo <kvalo@xxxxxxxxxxxxxx> --- drivers/net/wireless/marvell/libertas/rx.c | 11 ++--------- 1 file changed, 2 insertions(+), 9 deletions(-) --- a/drivers/net/wireless/marvell/libertas/rx.c +++ b/drivers/net/wireless/marvell/libertas/rx.c @@ -147,10 +147,7 @@ int lbs_process_rxed_packet(struct lbs_p dev->stats.rx_packets++; skb->protocol = eth_type_trans(skb, dev); - if (in_interrupt()) - netif_rx(skb); - else - netif_rx_ni(skb); + netif_rx_any_context(skb); ret = 0; done: @@ -265,11 +262,7 @@ static int process_rxed_802_11_packet(st dev->stats.rx_packets++; skb->protocol = eth_type_trans(skb, priv->dev); - - if (in_interrupt()) - netif_rx(skb); - else - netif_rx_ni(skb); + netif_rx_any_context(skb); ret = 0;
