On 2020-04-30 23:28, John Crispin wrote:
This patch adds support for ethernet rxtx mode to the driver. The
feature
is enabled via a new module parameter. If enabled to driver will enable
the feature on a per vif basis if all other requirements were met.
[...]
@@ -4339,7 +4352,22 @@ static int ath11k_mac_op_add_interface(struct
ieee80211_hw *hw,
spin_unlock_bh(&ar->data_lock);
param_id = WMI_VDEV_PARAM_TX_ENCAP_TYPE;
- param_value = ATH11K_HW_TXRX_NATIVE_WIFI;
+ if (ath11k_ath11k_frame_mode == ATH11K_HW_TXRX_ETHERNET)
+ switch (vif->type) {
+ case NL80211_IFTYPE_STATION:
+ case NL80211_IFTYPE_AP_VLAN:
+ case NL80211_IFTYPE_AP:
+ hw_encap = 1;
+ break;
+ default:
+ break;
+ }
+
+ if (ieee80211_set_hw_80211_encap(vif, hw_encap))
I see ieee80211_set_hw_80211_encap have check like this:
if (key->conf.cipher == WLAN_CIPHER_SUITE_TKIP)
enable = false;
so is it beeter to call it after associated/install key?
+ param_value = ATH11K_HW_TXRX_ETHERNET;
+ else
+ param_value = ATH11K_HW_TXRX_NATIVE_WIFI;
+
ret = ath11k_wmi_vdev_set_param_cmd(ar, arvif->vdev_id,
param_id, param_value);
if (ret) {
