For the 80MHz channel we need to set the PHY mode to one of four PHY modes
that span the 80MHz range.
This patch latches the hw_value PHY field previously defined for 5GHz
channels directly to the parameter passed to the firmware.
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
---
drivers/net/wireless/ath/wcn36xx/smd.c | 9 ++++++++-
1 file changed, 8 insertions(+), 1 deletion(-)
diff --git a/drivers/net/wireless/ath/wcn36xx/smd.c b/drivers/net/wireless/ath/wcn36xx/smd.c
index feeb27851f7a..7dada66b9f87 100644
--- a/drivers/net/wireless/ath/wcn36xx/smd.c
+++ b/drivers/net/wireless/ath/wcn36xx/smd.c
@@ -1508,6 +1508,7 @@ static int wcn36xx_smd_config_bss_v1(struct wcn36xx *wcn,
struct wcn36xx_hal_config_bss_params_v1 *bss;
struct wcn36xx_hal_config_bss_params bss_v0;
struct wcn36xx_hal_config_sta_params_v1 *sta;
+ struct cfg80211_chan_def *chandef;
int ret;
msg_body = kzalloc(sizeof(*msg_body), GFP_KERNEL);
@@ -1547,7 +1548,13 @@ static int wcn36xx_smd_config_bss_v1(struct wcn36xx *wcn,
bss->dtim_period = bss_v0.dtim_period;
bss->tx_channel_width_set = bss_v0.tx_channel_width_set;
bss->oper_channel = bss_v0.oper_channel;
- bss->ext_channel = bss_v0.ext_channel;
+
+ if (wcn->hw->conf.chandef.width == NL80211_CHAN_WIDTH_80) {
+ chandef = &wcn->hw->conf.chandef;
+ bss->ext_channel = HW_VALUE_PHY(chandef->chan->hw_value);
+ } else {
+ bss->ext_channel = bss_v0.ext_channel;
+ }
bss->reserved = bss_v0.reserved;
--
2.27.0
