It happened "Kernel panic - not syncing: hung_task: blocked tasks" when
test simulate crash and ifconfig down/rmmod meanwhile.
Test steps:
1.Test commands, either can reproduce the hang.
echo soft > /sys/kernel/debug/ieee80211/phy0/ath10k/simulate_fw_crash;sleep 0.05;ifconfig wlan0 down
echo soft > /sys/kernel/debug/ieee80211/phy0/ath10k/simulate_fw_crash;rmmod ath10k_sdio
2. dmesg:
[ 5622.548630] ath10k_sdio mmc1:0001:1: simulating soft firmware crash
[ 5622.655995] ieee80211 phy0: Hardware restart was requested
[ 5776.355164] INFO: task shill:1572 blocked for more than 122 seconds.
[ 5776.355687] INFO: task kworker/1:2:24437 blocked for more than 122 seconds.
[ 5776.359812] Kernel panic - not syncing: hung_task: blocked tasks
[ 5776.359836] CPU: 1 PID: 55 Comm: khungtaskd Tainted: G W 4.19.86 #137
[ 5776.359846] Hardware name: MediaTek krane sku176 board (DT)
[ 5776.359855] Call trace:
[ 5776.359868] dump_backtrace+0x0/0x170
[ 5776.359881] show_stack+0x20/0x2c
[ 5776.359896] dump_stack+0xd4/0x10c
[ 5776.359916] panic+0x12c/0x29c
[ 5776.359937] hung_task_panic+0x0/0x50
[ 5776.359953] kthread+0x120/0x130
[ 5776.359965] ret_from_fork+0x10/0x18
[ 5776.359986] SMP: stopping secondary CPUs
[ 5776.360012] Kernel Offset: 0x141ea00000 from 0xffffff8008000000
[ 5776.360026] CPU features: 0x0,2188200c
[ 5776.360035] Memory Limit: none
command "ifconfig wlan0 down" or "rmmod ath10k_sdio" will be blocked
callstack of ifconfig:
[<0>] __switch_to+0x120/0x13c
[<0>] msleep+0x28/0x38
[<0>] ath10k_sdio_hif_stop+0x24c/0x294 [ath10k_sdio]
[<0>] ath10k_core_stop+0x50/0x78 [ath10k_core]
[<0>] ath10k_halt+0x120/0x178 [ath10k_core]
[<0>] ath10k_stop+0x4c/0x8c [ath10k_core]
[<0>] drv_stop+0xe0/0x1e4 [mac80211]
[<0>] ieee80211_stop_device+0x48/0x54 [mac80211]
[<0>] ieee80211_do_stop+0x678/0x6f8 [mac80211]
[<0>] ieee80211_stop+0x20/0x30 [mac80211]
[<0>] __dev_close_many+0xb8/0x11c
[<0>] __dev_change_flags+0xe0/0x1d0
[<0>] dev_change_flags+0x30/0x6c
[<0>] devinet_ioctl+0x370/0x564
[<0>] inet_ioctl+0xdc/0x304
[<0>] sock_do_ioctl+0x50/0x288
[<0>] compat_sock_ioctl+0x1b4/0x1aac
[<0>] __se_compat_sys_ioctl+0x100/0x26fc
[<0>] __arm64_compat_sys_ioctl+0x20/0x2c
[<0>] el0_svc_common+0xa4/0x154
[<0>] el0_svc_compat_handler+0x2c/0x38
[<0>] el0_svc_compat+0x8/0x18
[<0>] 0xffffffffffffffff
callstack of rmmod:
[<0>] __switch_to+0x120/0x13c
[<0>] msleep+0x28/0x38
[<0>] ath10k_sdio_hif_stop+0x294/0x31c [ath10k_sdio]
[<0>] ath10k_core_stop+0x50/0x78 [ath10k_core]
[<0>] ath10k_halt+0x120/0x178 [ath10k_core]
[<0>] ath10k_stop+0x4c/0x8c [ath10k_core]
[<0>] drv_stop+0xe0/0x1e4 [mac80211]
[<0>] ieee80211_stop_device+0x48/0x54 [mac80211]
[<0>] ieee80211_do_stop+0x678/0x6f8 [mac80211]
[<0>] ieee80211_stop+0x20/0x30 [mac80211]
[<0>] __dev_close_many+0xb8/0x11c
[<0>] dev_close_many+0x70/0x100
[<0>] dev_close+0x4c/0x80
[<0>] cfg80211_shutdown_all_interfaces+0x50/0xcc [cfg80211]
[<0>] ieee80211_remove_interfaces+0x58/0x1a0 [mac80211]
[<0>] ieee80211_unregister_hw+0x40/0x100 [mac80211]
[<0>] ath10k_mac_unregister+0x1c/0x44 [ath10k_core]
[<0>] ath10k_core_unregister+0x38/0x7c [ath10k_core]
[<0>] ath10k_sdio_remove+0x8c/0xd0 [ath10k_sdio]
[<0>] sdio_bus_remove+0x48/0x108
[<0>] device_release_driver_internal+0x138/0x1ec
[<0>] driver_detach+0x6c/0xa8
[<0>] bus_remove_driver+0x78/0xa8
[<0>] driver_unregister+0x30/0x50
[<0>] sdio_unregister_driver+0x28/0x34
[<0>] cleanup_module+0x14/0x6bc [ath10k_sdio]
[<0>] __arm64_sys_delete_module+0x1e0/0x22c
[<0>] el0_svc_common+0xa4/0x154
[<0>] el0_svc_compat_handler+0x2c/0x38
[<0>] el0_svc_compat+0x8/0x18
[<0>] 0xffffffffffffffff
The test command run simulate_fw_crash firstly and it call into
ath10k_sdio_hif_stop from ath10k_core_restart, then napi_disable
is called and bit NAPI_STATE_SCHED is set. After that, function
ath10k_sdio_hif_stop is called again from ath10k_stop by command
"ifconfig wlan0 down" or "rmmod ath10k_sdio", then command blocked.
It is blocked by napi_synchronize, napi_disable will set bit with
NAPI_STATE_SCHED, and then napi_synchronize will enter dead loop
becuase bit NAPI_STATE_SCHED is set by napi_disable.
function of napi_synchronize
static inline void napi_synchronize(const struct napi_struct *n)
{
if (IS_ENABLED(CONFIG_SMP))
while (test_bit(NAPI_STATE_SCHED, &n->state))
msleep(1);
else
barrier();
}
function of napi_disable
void napi_disable(struct napi_struct *n)
{
might_sleep();
set_bit(NAPI_STATE_DISABLE, &n->state);
while (test_and_set_bit(NAPI_STATE_SCHED, &n->state))
msleep(1);
while (test_and_set_bit(NAPI_STATE_NPSVC, &n->state))
msleep(1);
hrtimer_cancel(&n->timer);
clear_bit(NAPI_STATE_DISABLE, &n->state);
}
Add flag for it avoid the hang and crash.
Tested-on: QCA6174 hw3.2 SDIO WLAN.RMH.4.4.1-00049
Signed-off-by: Wen Gong <wgong@xxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath10k/core.h | 1 +
drivers/net/wireless/ath/ath10k/sdio.c | 12 +++++++++---
2 files changed, 10 insertions(+), 3 deletions(-)
diff --git a/drivers/net/wireless/ath/ath10k/core.h b/drivers/net/wireless/ath/ath10k/core.h
index 5c18f6c20462..11a6b18c272d 100644
--- a/drivers/net/wireless/ath/ath10k/core.h
+++ b/drivers/net/wireless/ath/ath10k/core.h
@@ -1230,6 +1230,7 @@ struct ath10k {
/* NAPI */
struct net_device napi_dev;
struct napi_struct napi;
+ bool napi_enabled;
struct work_struct set_coverage_class_work;
/* protected by conf_mutex */
diff --git a/drivers/net/wireless/ath/ath10k/sdio.c b/drivers/net/wireless/ath/ath10k/sdio.c
index 81ddaafb6721..873f5492f93c 100644
--- a/drivers/net/wireless/ath/ath10k/sdio.c
+++ b/drivers/net/wireless/ath/ath10k/sdio.c
@@ -1859,7 +1859,10 @@ static int ath10k_sdio_hif_start(struct ath10k *ar)
struct ath10k_sdio *ar_sdio = ath10k_sdio_priv(ar);
int ret;
- napi_enable(&ar->napi);
+ if (!ar->napi_enabled) {
+ napi_enable(&ar->napi);
+ ar->napi_enabled = true;
+ }
/* Sleep 20 ms before HIF interrupts are disabled.
* This will give target plenty of time to process the BMI done
@@ -1986,8 +1989,11 @@ static void ath10k_sdio_hif_stop(struct ath10k *ar)
spin_unlock_bh(&ar_sdio->wr_async_lock);
- napi_synchronize(&ar->napi);
- napi_disable(&ar->napi);
+ if (ar->napi_enabled) {
+ napi_synchronize(&ar->napi);
+ napi_disable(&ar->napi);
+ ar->napi_enabled = false;
+ }
}
#ifdef CONFIG_PM
--
2.23.0
