Here interrupt and ring configuration changes, and some smaller stuff, are done to get QCA6390 working. This is the last patchset adding initial QCA6390 support. Now it's possible to associate to an AP and ping with an QCA6390 device. This patchset depends on the patchset: ath11k: CE and HAL support for QCA6390 Kalle Carl Huang (9): ath11k: enable DP interrupt setup for QCA6390 ath11k: don't initialize rxdma1 related ring ath11k: setup QCA6390 rings for both rxdmas ath11k: refine the phy_id check in ath11k_reg_chan_list_event ath11k: delay vdev_start for QCA6390 ath11k: assign correct search flag and type for QCA6390 ath11k: process both lmac rings for QCA6390 ath11k: use TCL_DATA_RING_0 for QCA6390 ath11k: reset MHI during power down and power up drivers/net/wireless/ath/ath11k/core.c | 14 +- drivers/net/wireless/ath/ath11k/core.h | 7 + drivers/net/wireless/ath/ath11k/debug.c | 41 ++++-- drivers/net/wireless/ath/ath11k/dp.c | 189 ++++++++++++++++++++---- drivers/net/wireless/ath/ath11k/dp.h | 7 +- drivers/net/wireless/ath/ath11k/dp_rx.c | 208 +++++++++++++++++++------- drivers/net/wireless/ath/ath11k/dp_tx.c | 65 +++++--- drivers/net/wireless/ath/ath11k/hw.c | 68 +++++++++ drivers/net/wireless/ath/ath11k/hw.h | 40 ++++- drivers/net/wireless/ath/ath11k/mac.c | 66 ++++++++- drivers/net/wireless/ath/ath11k/mhi.c | 46 +++++- drivers/net/wireless/ath/ath11k/mhi.h | 11 ++ drivers/net/wireless/ath/ath11k/pci.c | 254 +++++++++++++++++++++++++++++++- drivers/net/wireless/ath/ath11k/pci.h | 17 +++ drivers/net/wireless/ath/ath11k/wmi.c | 7 +- 15 files changed, 907 insertions(+), 133 deletions(-) -- 2.7.4
