On 7/30/20 5:30 AM, Johannes Berg wrote:
Hi,
I larded up my 5.4 kernel with KASAN and lockdep, and ran some tests. This is with my
patch that keeps from busy-spinning forever (see previous ignored patch).
Right, sorry, hadn't gotten to patches in a while.
After a few restarts and FW crashes, the ax200 could not recover firmware. There
were lots of sdata-in-driver errors, and then KASAN hit a use-after-free issue
related to ax200 accessing sta object that was previously deleted.
Now, I think I know why:
In the ieee80211_handle_reconfig_failure(struct ieee80211_local *local)
method, it will clear the SDATA_IN_DRIVER flag, and according to comments,
this is run when firmware cannot be recovered. But, just because FW is
dead does not mean that the driver itself has cleaned up its state.
So question is, should ax200 (and all drivers) be responsible for cleaning
up all state when FW cannot be recovered, or should instead mac80211 do cleanup
in this case by, among other things, not clearing that flag (and probably
not doing the ctx->driver_present = false; config as well)?
I think it should be the driver. It's not clear _why_ the driver failed,
after all. If the firmware is still alive and just rejected something
then perhaps rolling things back will work. But if the firmware just
died again, that will just cause even more trouble.
The current code clears state without actually notifying the driver, so it
is causing mac80211 to be out of sync with the driver. I can't see how that
is a good idea. This is root cause of the issue that causes the busy-spin
related to sdata-in-driver / EIO as far as I can tell.
When we get to the state where the driver cannot properly recover from
a fW crash, which is what this code is about, then we just need to keep
from killing the rest of the system with busy-spins and memory corruption errors
and hope it can limp on.
Some day, we should notify user-space that a radio is unrecoverable
(short of rmmod/modprobe perhaps), and that it should take appropriate
action. If this is an AP on a pole, for instance, the WDT should be triggered
and system rebooted most likely.
Thanks,
Ben
johannes
--
Ben Greear <greearb@xxxxxxxxxxxxxxx>
Candela Technologies Inc http://www.candelatech.com
