QCA6390 chipsets is PCI based 11ax chipset to be supported in ath11k.
Add PCI client driver for QCA6390 chipset with enumeration/resource initialization/msi vector mapping.
With these changes driver is splitted in two modules(bus layer module/ common core module).
This is required due to following reasons.
1) PCI based transport layer for QCA6390 chipsets.
2) FW loading based on MHI protocol unlike rproc in IPQ8074A.
3) MSI based data path/CE/fw RAM dump interrupt.
4) CE assignments is different.
5) Different boot up sequence due to requirement of voltage regulators/bootstrap
pinctrls for QCA6390.
6) Clear separation in bus level operation.
For AHB based devices:
ath11k_ahb.ko
ath11k_ko
For PCI based devices:
ath11k_pci.ko
ath11k.ko
Tested HW:
IPQ8074A
X86 + QCA6390: pci probe/resource setup
Govind Singh (4):
ath11k: Add PCI client driver for QCA6390 chipset
ath11k: setup pci resource for QCA6390 target
ath11k: Add msi config init for QCA6390
ath11k: Register mhi controller device for qca6390
drivers/net/wireless/ath/ath11k/Kconfig | 13 +-
drivers/net/wireless/ath/ath11k/Makefile | 7 +-
drivers/net/wireless/ath/ath11k/ahb.c | 71 -----
drivers/net/wireless/ath/ath11k/ce.c | 2 +
drivers/net/wireless/ath/ath11k/core.c | 7 +
drivers/net/wireless/ath/ath11k/core.h | 11 +-
drivers/net/wireless/ath/ath11k/debug.c | 6 +-
drivers/net/wireless/ath/ath11k/debug.h | 1 +
drivers/net/wireless/ath/ath11k/dp.c | 1 +
drivers/net/wireless/ath/ath11k/hal.c | 1 +
drivers/net/wireless/ath/ath11k/hif.h | 77 ++++-
drivers/net/wireless/ath/ath11k/mhi.c | 379 ++++++++++++++++++++++
drivers/net/wireless/ath/ath11k/mhi.h | 28 ++
drivers/net/wireless/ath/ath11k/pci.c | 385 +++++++++++++++++++++++
drivers/net/wireless/ath/ath11k/pci.h | 49 +++
15 files changed, 954 insertions(+), 84 deletions(-)
create mode 100644 drivers/net/wireless/ath/ath11k/mhi.c
create mode 100644 drivers/net/wireless/ath/ath11k/mhi.h
create mode 100644 drivers/net/wireless/ath/ath11k/pci.c
create mode 100644 drivers/net/wireless/ath/ath11k/pci.h
--
2.22.0
