On 2020-05-04 08:41, Markus Theil wrote:
ath11k currently reports survey results for the last interval between
each
invocation of NL80211_CMD_GET_SURVEY. For concurrent invocations, this
can lead to unexpectedly small results, e.g. when hostapd uses survey
data and iw survey dump is invoked in parallel. Fix this by returning
cumulative results, that don't depend on the last invocation. Other
drivers, e.g. ath9k or mt76 also use this behavior.
Signed-off-by: Markus Theil <markus.theil@xxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath11k/wmi.c | 20 ++++++++++----------
1 file changed, 10 insertions(+), 10 deletions(-)
diff --git a/drivers/net/wireless/ath/ath11k/wmi.c
b/drivers/net/wireless/ath/ath11k/wmi.c
index c2a972377687..322ddfda5bfd 100644
--- a/drivers/net/wireless/ath/ath11k/wmi.c
+++ b/drivers/net/wireless/ath/ath11k/wmi.c
@@ -5610,16 +5610,16 @@ ath11k_pdev_bss_chan_info_event(struct
ath11k_base *ab, struct sk_buff *skb)
survey = &ar->survey[idx];
- survey->noise = bss_ch_info_ev.noise_floor;
- survey->time = div_u64(total, cc_freq_hz);
- survey->time_busy = div_u64(busy, cc_freq_hz);
- survey->time_rx = div_u64(rx_bss, cc_freq_hz);
- survey->time_tx = div_u64(tx, cc_freq_hz);
- survey->filled |= (SURVEY_INFO_NOISE_DBM |
- SURVEY_INFO_TIME |
- SURVEY_INFO_TIME_BUSY |
- SURVEY_INFO_TIME_RX |
- SURVEY_INFO_TIME_TX);
+ survey->noise = bss_ch_info_ev.noise_floor;
+ survey->time += div_u64(total, cc_freq_hz);
+ survey->time_busy += div_u64(busy, cc_freq_hz);
+ survey->time_rx += div_u64(rx_bss, cc_freq_hz);
+ survey->time_tx += div_u64(tx, cc_freq_hz);
+ survey->filled |= (SURVEY_INFO_NOISE_DBM |
+ SURVEY_INFO_TIME |
+ SURVEY_INFO_TIME_BUSY |
+ SURVEY_INFO_TIME_RX |
+ SURVEY_INFO_TIME_TX);
Markus,
It depends on type of survey request is given to firmware. In ath11k,
firmware reports
accumulated values. So the above addition is wrong and report double
value. Have you
tested this change?
-Rajkumar
