Hi, > The rt2500 driver in 2.6.27-rc3 (v2.6.27-rc3-552-g3c3a15a) constantly > produces a lot of this messages in log (slowdown quite noticable): > > kernel: phy0 -> rt2500pci_bbp_read: Error - BBPCSR register busy. Read failed. > kernel: phy0 -> rt2500pci_bbp_write: Error - BBPCSR register busy. Write failed. > last message repeated 40 times > kernel: phy0 -> rt2500pci_rf_write: Error - RFCSR register busy. Write failed. > last message repeated 7 times > kernel: phy0 -> rt2500pci_bbp_write: Error - BBPCSR register busy. Write failed. This is a bad sign, the slowdown is expected since the driver is continuously looping waiting for the registers to become available. Did this PCI card work in the past, and if so with what driver? Does this card work on another PC, or does the windows or legacy driver work with this card? (Yes, all suggestions above imply suspicion about the hardware itself rather then the driver) Ivo > The card is a RaLink RT2500 PCI (not mini-PCI, it is a normal desktop > system, Gigabyte GA-8IPE1000 motherboard): > > 02:04.0 Ethernet controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01) > Subsystem: Micro-Star International Co., Ltd. Unknown device 6834 > Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- > Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR+ > Latency: 32, Cache Line Size: 32 bytes > Interrupt: pin A routed to IRQ 11 > Region 0: Memory at fa000000 (32-bit, non-prefetchable) [size=8K] > Capabilities: [40] Power Management version 2 > Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) > Status: D0 PME-Enable- DSel=0 DScale=0 PME- > > The system is a P4 with HT enabled (and active). The .config is below: -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html