From: Karthikeyan Periyasamy <periyasa@xxxxxxxxxxxxxx> WMI_VDEV_SET_WMM_PARAMS commmand expects the txoplimit param in the units of 32 microseconds. convert the txop unit from 32 microseconds to absolute microseconds leads to the higher burst values which is incorrect. so no need to convert the txop unit from 32 microseconds to absolute microseconds. Signed-off-by: Karthikeyan Periyasamy <periyasa@xxxxxxxxxxxxxx> Signed-off-by: Kalle Valo <kvalo@xxxxxxxxxxxxxx> --- drivers/net/wireless/ath/ath11k/mac.c | 7 +------ 1 file changed, 1 insertion(+), 6 deletions(-) diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c index 6f82fdbbd358..412c258143ca 100644 --- a/drivers/net/wireless/ath/ath11k/mac.c +++ b/drivers/net/wireless/ath/ath11k/mac.c @@ -3023,12 +3023,7 @@ static int ath11k_mac_op_conf_tx(struct ieee80211_hw *hw, p->cwmin = params->cw_min; p->cwmax = params->cw_max; p->aifs = params->aifs; - - /* The channel time duration programmed in the HW is in absolute - * microseconds, while mac80211 gives the txop in units of - * 32 microseconds. - */ - p->txop = params->txop * 32; + p->txop = params->txop; ret = ath11k_wmi_send_wmm_update_cmd_tlv(ar, arvif->vdev_id, &arvif->wmm_params); -- 2.7.4
