From: Yan-Hsuan Chuang <yhchuang@xxxxxxxxxxx> After firmware has been downloaded, driver should send some information to it through H2C commands. Those H2C commands are transmitted through TX path. But before HCI has been started, the TX path is not working completely. Such as PCI interfaces, the interrupts are not enabled, hence TX interrupts will not be issued after H2C skb has been DMAed to the device. And the H2C skbs will not be released until the device is powered off. Signed-off-by: Yan-Hsuan Chuang <yhchuang@xxxxxxxxxxx> --- drivers/net/wireless/realtek/rtw88/mac.c | 3 --- drivers/net/wireless/realtek/rtw88/main.c | 4 ++++ 2 files changed, 4 insertions(+), 3 deletions(-) diff --git a/drivers/net/wireless/realtek/rtw88/mac.c b/drivers/net/wireless/realtek/rtw88/mac.c index fc14b37d927d..b61b073031e5 100644 --- a/drivers/net/wireless/realtek/rtw88/mac.c +++ b/drivers/net/wireless/realtek/rtw88/mac.c @@ -707,9 +707,6 @@ int rtw_download_firmware(struct rtw_dev *rtwdev, struct rtw_fw_state *fw) rtwdev->h2c.last_box_num = 0; rtwdev->h2c.seq = 0; - rtw_fw_send_general_info(rtwdev); - rtw_fw_send_phydm_info(rtwdev); - rtw_flag_set(rtwdev, RTW_FLAG_FW_RUNNING); return 0; diff --git a/drivers/net/wireless/realtek/rtw88/main.c b/drivers/net/wireless/realtek/rtw88/main.c index fc8f6213fc8f..6dd457741b15 100644 --- a/drivers/net/wireless/realtek/rtw88/main.c +++ b/drivers/net/wireless/realtek/rtw88/main.c @@ -704,6 +704,10 @@ static int rtw_power_on(struct rtw_dev *rtwdev) goto err_off; } + /* send H2C after HCI has started */ + rtw_fw_send_general_info(rtwdev); + rtw_fw_send_phydm_info(rtwdev); + wifi_only = !rtwdev->efuse.btcoex; rtw_coex_power_on_setting(rtwdev); rtw_coex_init_hw_config(rtwdev, wifi_only); -- 2.17.1
