On Fri, Aug 30, 2019 at 10:53 AM Nicolas Boichat <drinkcat@xxxxxxxxxxxx> wrote:
>
> On Thu, Aug 29, 2019 at 12:18 AM Wen Gong <wgong@xxxxxxxxxxxxxx> wrote:
> >
> > When the FW bundles multiple packets, pkt->act_len may be incorrect
> > as it refers to the first packet only (however, the FW will only
> > bundle packets that fit into the same pkt->alloc_len).
> >
> > Before this patch, the skb length would be set (incorrectly) to
> > pkt->act_len in ath10k_sdio_mbox_rx_packet, and then later manually
> > adjusted in ath10k_sdio_mbox_rx_process_packet.
> >
> > The first problem is that ath10k_sdio_mbox_rx_process_packet does not
> > use proper skb_put commands to adjust the length (it directly changes
> > skb->len), so we end up with a mismatch between skb->head + skb->tail
> > and skb->data + skb->len. This is quite serious, and causes corruptions
> > in the TCP stack, as the stack tries to coalesce packets, and relies
> > on skb->tail being correct (that is, skb_tail_pointer must point to
> > the first byte_after_ the data).
> >
> > Instead of re-adjusting the size in ath10k_sdio_mbox_rx_process_packet,
> > this moves the code to ath10k_sdio_mbox_rx_packet, and also add a
> > bounds check, as skb_put would crash the kernel if not enough space is
> > available.
> >
> > Tested with QCA6174 SDIO with firmware
> > WLAN.RMH.4.4.1-00007-QCARMSWP-1.
> >
> > Signed-off-by: Nicolas Boichat <drinkcat@xxxxxxxxxxxx>
> > Signed-off-by: Wen Gong <wgong@xxxxxxxxxxxxxx>
>
> You are not the author of this patch, please reset the author in your
> git tree and resend.
>
> Once you do that, the first line should say:
> From: Nicolas Boichat <drinkcat@xxxxxxxxxxxx>
>
> Without this fix:
> NACKed-by: Nicolas Boichat <drinkcat@xxxxxxxxxxxx>
>
Also you dropped the Fixes line:
Fixes: 8530b4e7b22bc3b ("ath10k: sdio: set skb len for all rx packets")
> > ---
> > v2:no this patch
> > v2:new added
> > drivers/net/wireless/ath/ath10k/sdio.c | 27 +++++++++++++++++++--------
> > 1 file changed, 19 insertions(+), 8 deletions(-)
> >
> > diff --git a/drivers/net/wireless/ath/ath10k/sdio.c b/drivers/net/wireless/ath/ath10k/sdio.c
> > index 8ed4fbd..1127e44 100644
> > --- a/drivers/net/wireless/ath/ath10k/sdio.c
> > +++ b/drivers/net/wireless/ath/ath10k/sdio.c
> > @@ -381,16 +381,11 @@ static int ath10k_sdio_mbox_rx_process_packet(struct ath10k *ar,
> > struct ath10k_htc_hdr *htc_hdr = (struct ath10k_htc_hdr *)skb->data;
> > bool trailer_present = htc_hdr->flags & ATH10K_HTC_FLAG_TRAILER_PRESENT;
> > enum ath10k_htc_ep_id eid;
> > - u16 payload_len;
> > u8 *trailer;
> > int ret;
> >
> > - payload_len = le16_to_cpu(htc_hdr->len);
> > - skb->len = payload_len + sizeof(struct ath10k_htc_hdr);
> > -
> > if (trailer_present) {
> > - trailer = skb->data + sizeof(*htc_hdr) +
> > - payload_len - htc_hdr->trailer_len;
> > + trailer = skb->data + skb->len - htc_hdr->trailer_len;
> >
> > eid = pipe_id_to_eid(htc_hdr->eid);
> >
> > @@ -632,13 +627,29 @@ static int ath10k_sdio_mbox_rx_packet(struct ath10k *ar,
> > {
> > struct ath10k_sdio *ar_sdio = ath10k_sdio_priv(ar);
> > struct sk_buff *skb = pkt->skb;
> > + struct ath10k_htc_hdr *htc_hdr;
> > int ret;
> >
> > ret = ath10k_sdio_readsb(ar, ar_sdio->mbox_info.htc_addr,
> > skb->data, pkt->alloc_len);
> > +
> > + if (!ret) {
> > + /* Update actual length. The original length may be incorrect,
> > + * as the FW will bundle multiple packets as long as their sizes
> > + * fit within the same aligned length (pkt->alloc_len).
> > + */
> > + htc_hdr = (struct ath10k_htc_hdr *)skb->data;
> > + pkt->act_len = le16_to_cpu(htc_hdr->len) + sizeof(*htc_hdr);
> > + if (pkt->act_len <= pkt->alloc_len) {
> > + skb_put(skb, pkt->act_len);
> > + } else {
> > + ath10k_warn(ar, "rx packet too large (%zu > %zu)\n",
> > + pkt->act_len, pkt->alloc_len);
> > + ret = -EMSGSIZE;
> > + }
> > + }
> > +
> > pkt->status = ret;
> > - if (!ret)
> > - skb_put(skb, pkt->act_len);
> >
> > return ret;
> > }
> > --
> > 1.9.1
> >
