From: Emmanuel Grumbach <emmanuel.grumbach@xxxxxxxxx>
This is always set to IWL_PLAT_PM_MODE_DISABLED
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@xxxxxxxxx>
Signed-off-by: Luca Coelho <luciano.coelho@xxxxxxxxx>
---
.../net/wireless/intel/iwlwifi/iwl-trans.h | 33 +++----------------
drivers/net/wireless/intel/iwlwifi/pcie/drv.c | 28 ----------------
.../net/wireless/intel/iwlwifi/pcie/trans.c | 9 -----
3 files changed, 5 insertions(+), 65 deletions(-)
diff --git a/drivers/net/wireless/intel/iwlwifi/iwl-trans.h b/drivers/net/wireless/intel/iwlwifi/iwl-trans.h
index 034c935b5579..b50290a724ff 100644
--- a/drivers/net/wireless/intel/iwlwifi/iwl-trans.h
+++ b/drivers/net/wireless/intel/iwlwifi/iwl-trans.h
@@ -630,9 +630,6 @@ enum iwl_trans_state {
/**
* DOC: Platform power management
*
- * There are two types of platform power management: system-wide
- * (WoWLAN) and runtime.
- *
* In system-wide power management the entire platform goes into a low
* power state (e.g. idle or suspend to RAM) at the same time and the
* device is configured as a wakeup source for the entire platform.
@@ -641,48 +638,32 @@ enum iwl_trans_state {
* put the platform in low power mode). The device's behavior in this
* mode is dictated by the wake-on-WLAN configuration.
*
- * In runtime power management, only the devices which are themselves
- * idle enter a low power state. This is done at runtime, which means
- * that the entire system is still running normally. This mode is
- * usually triggered automatically by the device driver and requires
- * the ability to enter and exit the low power modes in a very short
- * time, so there is not much impact in usability.
- *
* The terms used for the device's behavior are as follows:
*
* - D0: the device is fully powered and the host is awake;
* - D3: the device is in low power mode and only reacts to
* specific events (e.g. magic-packet received or scan
* results found);
- * - D0I3: the device is in low power mode and reacts to any
- * activity (e.g. RX);
*
* These terms reflect the power modes in the firmware and are not to
- * be confused with the physical device power state. The NIC can be
- * in D0I3 mode even if, for instance, the PCI device is in D3 state.
+ * be confused with the physical device power state.
*/
/**
* enum iwl_plat_pm_mode - platform power management mode
*
* This enumeration describes the device's platform power management
- * behavior when in idle mode (i.e. runtime power management) or when
- * in system-wide suspend (i.e WoWLAN).
+ * behavior when in system-wide suspend (i.e WoWLAN).
*
* @IWL_PLAT_PM_MODE_DISABLED: power management is disabled for this
- * device. At runtime, this means that nothing happens and the
- * device always remains in active. In system-wide suspend mode,
- * it means that the all connections will be closed automatically
- * by mac80211 before the platform is suspended.
+ * device. In system-wide suspend mode, it means that the all
+ * connections will be closed automatically by mac80211 before
+ * the platform is suspended.
* @IWL_PLAT_PM_MODE_D3: the device goes into D3 mode (i.e. WoWLAN).
- * For runtime power management, this mode is not officially
- * supported.
- * @IWL_PLAT_PM_MODE_D0I3: the device goes into D0I3 mode.
*/
enum iwl_plat_pm_mode {
IWL_PLAT_PM_MODE_DISABLED,
IWL_PLAT_PM_MODE_D3,
- IWL_PLAT_PM_MODE_D0I3,
};
/* Max time to wait for trans to become idle/non-idle on d0i3
@@ -795,9 +776,6 @@ struct iwl_trans_debug {
* @system_pm_mode: the system-wide power management mode in use.
* This mode is set dynamically, depending on the WoWLAN values
* configured from the userspace at runtime.
- * @runtime_pm_mode: the runtime power management mode in use. This
- * mode is set during the initialization phase and is not
- * supposed to change during runtime.
*/
struct iwl_trans {
const struct iwl_trans_ops *ops;
@@ -842,7 +820,6 @@ struct iwl_trans {
struct iwl_self_init_dram init_dram;
enum iwl_plat_pm_mode system_pm_mode;
- enum iwl_plat_pm_mode runtime_pm_mode;
/* pointer to trans specific struct */
/*Ensure that this pointer will always be aligned to sizeof pointer */
diff --git a/drivers/net/wireless/intel/iwlwifi/pcie/drv.c b/drivers/net/wireless/intel/iwlwifi/pcie/drv.c
index 2a34f074d72c..10c9167d78fa 100644
--- a/drivers/net/wireless/intel/iwlwifi/pcie/drv.c
+++ b/drivers/net/wireless/intel/iwlwifi/pcie/drv.c
@@ -1076,25 +1076,6 @@ static int iwl_pci_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
/* register transport layer debugfs here */
iwl_trans_pcie_dbgfs_register(iwl_trans);
- /* if RTPM is in use, enable it in our device */
- if (iwl_trans->runtime_pm_mode != IWL_PLAT_PM_MODE_DISABLED) {
- /* We explicitly set the device to active here to
- * clear contingent errors.
- */
- pm_runtime_set_active(&pdev->dev);
-
- pm_runtime_set_autosuspend_delay(&pdev->dev,
- iwlwifi_mod_params.d0i3_timeout);
- pm_runtime_use_autosuspend(&pdev->dev);
-
- /* We are not supposed to call pm_runtime_allow() by
- * ourselves, but let userspace enable runtime PM via
- * sysfs. However, since we don't enable this from
- * userspace yet, we need to allow/forbid() ourselves.
- */
- pm_runtime_allow(&pdev->dev);
- }
-
/* The PCI device starts with a reference taken and we are
* supposed to release it here. But to simplify the
* interaction with the opmode, we don't do it now, but let
@@ -1112,15 +1093,6 @@ static void iwl_pci_remove(struct pci_dev *pdev)
{
struct iwl_trans *trans = pci_get_drvdata(pdev);
- /* if RTPM was in use, restore it to the state before probe */
- if (trans->runtime_pm_mode != IWL_PLAT_PM_MODE_DISABLED) {
- /* We should not call forbid here, but we do for now.
- * Check the comment to pm_runtime_allow() in
- * iwl_pci_probe().
- */
- pm_runtime_forbid(trans->dev);
- }
-
iwl_drv_stop(trans->drv);
iwl_trans_pcie_free(trans);
diff --git a/drivers/net/wireless/intel/iwlwifi/pcie/trans.c b/drivers/net/wireless/intel/iwlwifi/pcie/trans.c
index 3a4be2ff3d42..8eaacf423d33 100644
--- a/drivers/net/wireless/intel/iwlwifi/pcie/trans.c
+++ b/drivers/net/wireless/intel/iwlwifi/pcie/trans.c
@@ -3312,18 +3312,11 @@ static struct iwl_trans_dump_data
#ifdef CONFIG_PM_SLEEP
static int iwl_trans_pcie_suspend(struct iwl_trans *trans)
{
- if (trans->runtime_pm_mode == IWL_PLAT_PM_MODE_D0I3 &&
- (trans->system_pm_mode == IWL_PLAT_PM_MODE_D0I3))
- return iwl_pci_fw_enter_d0i3(trans);
-
return 0;
}
static void iwl_trans_pcie_resume(struct iwl_trans *trans)
{
- if (trans->runtime_pm_mode == IWL_PLAT_PM_MODE_D0I3 &&
- (trans->system_pm_mode == IWL_PLAT_PM_MODE_D0I3))
- iwl_pci_fw_exit_d0i3(trans);
}
#endif /* CONFIG_PM_SLEEP */
@@ -3660,8 +3653,6 @@ struct iwl_trans *iwl_trans_pcie_alloc(struct pci_dev *pdev,
WQ_HIGHPRI | WQ_UNBOUND, 1);
INIT_WORK(&trans_pcie->rba.rx_alloc, iwl_pcie_rx_allocator_work);
- trans->runtime_pm_mode = IWL_PLAT_PM_MODE_DISABLED;
-
#ifdef CONFIG_IWLWIFI_DEBUGFS
trans_pcie->fw_mon_data.state = IWL_FW_MON_DBGFS_STATE_CLOSED;
mutex_init(&trans_pcie->fw_mon_data.mutex);
--
2.23.0.rc1
