All,
I can now see my wireless connection using iwlist but when I use iwconfig, the acceess point keeps saying not associated. It has never worked
I have the 2.6.26 kernel loaded on suse with the lastest b43 firmware.
This is a broadcom 4306 rev. 3.
This is from iwconfig
wlan0 IEEE 802.11 ESSID:"wireless_g"
Mode:Managed Frequency:2.437 GHz Access Point: Not-Associated
Tx-Power=27 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
dmesg | grep b43
b43-phy0: Broadcom 4306 WLAN found
input: b43-phy0 as /devices/virtual/input/input5
firmware: requesting b43/ucode5.fw
firmware: requesting b43/pcm5.fw
firmware: requesting b43/b0g0initvals5.fw
firmware: requesting b43/b0g0bsinitvals5.fw
b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
Registered led device: b43-phy0::tx
Registered led device: b43-phy0::rx
Registered led device: b43-phy0::radio
This statement says I might should be using b43legacy for my card.
4306 and 4309 cards with a MAC core revision of 4 or less should also use b43legacy. b43 should be used on all other cards.
lspci
01:05.0 Network controller: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller (rev 03)
I would appreciate any help on this.
Thanks,
Richard Schneiderman
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
