From: Emmanuel Grumbach <emmanuel.grumbach@xxxxxxxxx>
When we have a single image (same firmware image for INIT and
OPERATIONAL), we couldn't load the driver and register to the
stack if we had hardware RF-Kill asserted.
Fix this. This required a few changes:
1) Run the firmware as part of the INIT phase even if its
ucode_type is not IWL_UCODE_INIT.
2) Send the commands that are sent to the unified image in
INIT flow even in RF-Kill.
3) Don't ask the transport to stop the hardware upon RF-Kill
interrupt if the RF-Kill is asserted.
4) Allow the RF-Kill interrupt to take us out of L1A so that
the RF-Kill interrupt will be received by the host (to
enable the radio).
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@xxxxxxxxx>
Signed-off-by: Luca Coelho <luciano.coelho@xxxxxxxxx>
---
drivers/net/wireless/intel/iwlwifi/mvm/fw.c | 23 ++++++++++++++-----
.../net/wireless/intel/iwlwifi/mvm/mac80211.c | 2 +-
drivers/net/wireless/intel/iwlwifi/mvm/mvm.h | 2 +-
drivers/net/wireless/intel/iwlwifi/mvm/ops.c | 17 ++++++++++----
.../wireless/intel/iwlwifi/pcie/internal.h | 2 +-
5 files changed, 33 insertions(+), 13 deletions(-)
diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/fw.c b/drivers/net/wireless/intel/iwlwifi/mvm/fw.c
index ab68b5d53ec9..153717587aeb 100644
--- a/drivers/net/wireless/intel/iwlwifi/mvm/fw.c
+++ b/drivers/net/wireless/intel/iwlwifi/mvm/fw.c
@@ -311,6 +311,8 @@ static int iwl_mvm_load_ucode_wait_alive(struct iwl_mvm *mvm,
int ret;
enum iwl_ucode_type old_type = mvm->fwrt.cur_fw_img;
static const u16 alive_cmd[] = { MVM_ALIVE };
+ bool run_in_rfkill =
+ ucode_type == IWL_UCODE_INIT || iwl_mvm_has_unified_ucode(mvm);
if (ucode_type == IWL_UCODE_REGULAR &&
iwl_fw_dbg_conf_usniffer(mvm->fw, FW_DBG_START_FROM_ALIVE) &&
@@ -328,7 +330,12 @@ static int iwl_mvm_load_ucode_wait_alive(struct iwl_mvm *mvm,
alive_cmd, ARRAY_SIZE(alive_cmd),
iwl_alive_fn, &alive_data);
- ret = iwl_trans_start_fw(mvm->trans, fw, ucode_type == IWL_UCODE_INIT);
+ /*
+ * We want to load the INIT firmware even in RFKILL
+ * For the unified firmware case, the ucode_type is not
+ * INIT, but we still need to run it.
+ */
+ ret = iwl_trans_start_fw(mvm->trans, fw, run_in_rfkill);
if (ret) {
iwl_fw_set_current_image(&mvm->fwrt, old_type);
iwl_remove_notification(&mvm->notif_wait, &alive_wait);
@@ -433,7 +440,8 @@ static int iwl_run_unified_mvm_ucode(struct iwl_mvm *mvm, bool read_nvm)
* commands
*/
ret = iwl_mvm_send_cmd_pdu(mvm, WIDE_ID(SYSTEM_GROUP,
- INIT_EXTENDED_CFG_CMD), 0,
+ INIT_EXTENDED_CFG_CMD),
+ CMD_SEND_IN_RFKILL,
sizeof(init_cfg), &init_cfg);
if (ret) {
IWL_ERR(mvm, "Failed to run init config command: %d\n",
@@ -457,7 +465,8 @@ static int iwl_run_unified_mvm_ucode(struct iwl_mvm *mvm, bool read_nvm)
}
ret = iwl_mvm_send_cmd_pdu(mvm, WIDE_ID(REGULATORY_AND_NVM_GROUP,
- NVM_ACCESS_COMPLETE), 0,
+ NVM_ACCESS_COMPLETE),
+ CMD_SEND_IN_RFKILL,
sizeof(nvm_complete), &nvm_complete);
if (ret) {
IWL_ERR(mvm, "Failed to run complete NVM access: %d\n",
@@ -482,6 +491,8 @@ static int iwl_run_unified_mvm_ucode(struct iwl_mvm *mvm, bool read_nvm)
}
}
+ mvm->rfkill_safe_init_done = true;
+
return 0;
error:
@@ -526,7 +537,7 @@ int iwl_run_init_mvm_ucode(struct iwl_mvm *mvm, bool read_nvm)
lockdep_assert_held(&mvm->mutex);
- if (WARN_ON_ONCE(mvm->calibrating))
+ if (WARN_ON_ONCE(mvm->rfkill_safe_init_done))
return 0;
iwl_init_notification_wait(&mvm->notif_wait,
@@ -576,7 +587,7 @@ int iwl_run_init_mvm_ucode(struct iwl_mvm *mvm, bool read_nvm)
goto remove_notif;
}
- mvm->calibrating = true;
+ mvm->rfkill_safe_init_done = true;
/* Send TX valid antennas before triggering calibrations */
ret = iwl_send_tx_ant_cfg(mvm, iwl_mvm_get_valid_tx_ant(mvm));
@@ -612,7 +623,7 @@ int iwl_run_init_mvm_ucode(struct iwl_mvm *mvm, bool read_nvm)
remove_notif:
iwl_remove_notification(&mvm->notif_wait, &calib_wait);
out:
- mvm->calibrating = false;
+ mvm->rfkill_safe_init_done = false;
if (iwlmvm_mod_params.init_dbg && !mvm->nvm_data) {
/* we want to debug INIT and we have no NVM - fake */
mvm->nvm_data = kzalloc(sizeof(struct iwl_nvm_data) +
diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c b/drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c
index 5c52469288be..fdbabca0280e 100644
--- a/drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c
+++ b/drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c
@@ -1209,7 +1209,7 @@ static void iwl_mvm_restart_cleanup(struct iwl_mvm *mvm)
mvm->scan_status = 0;
mvm->ps_disabled = false;
- mvm->calibrating = false;
+ mvm->rfkill_safe_init_done = false;
/* just in case one was running */
iwl_mvm_cleanup_roc_te(mvm);
diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/mvm.h b/drivers/net/wireless/intel/iwlwifi/mvm/mvm.h
index 7b829a5be773..02efcf2189c4 100644
--- a/drivers/net/wireless/intel/iwlwifi/mvm/mvm.h
+++ b/drivers/net/wireless/intel/iwlwifi/mvm/mvm.h
@@ -880,7 +880,7 @@ struct iwl_mvm {
struct iwl_mvm_vif *bf_allowed_vif;
bool hw_registered;
- bool calibrating;
+ bool rfkill_safe_init_done;
bool support_umac_log;
u32 ampdu_ref;
diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/ops.c b/drivers/net/wireless/intel/iwlwifi/mvm/ops.c
index 004de67f9157..fad3bf563712 100644
--- a/drivers/net/wireless/intel/iwlwifi/mvm/ops.c
+++ b/drivers/net/wireless/intel/iwlwifi/mvm/ops.c
@@ -1209,7 +1209,8 @@ void iwl_mvm_set_hw_ctkill_state(struct iwl_mvm *mvm, bool state)
static bool iwl_mvm_set_hw_rfkill_state(struct iwl_op_mode *op_mode, bool state)
{
struct iwl_mvm *mvm = IWL_OP_MODE_GET_MVM(op_mode);
- bool calibrating = READ_ONCE(mvm->calibrating);
+ bool rfkill_safe_init_done = READ_ONCE(mvm->rfkill_safe_init_done);
+ bool unified = iwl_mvm_has_unified_ucode(mvm);
if (state)
set_bit(IWL_MVM_STATUS_HW_RFKILL, &mvm->status);
@@ -1218,15 +1219,23 @@ static bool iwl_mvm_set_hw_rfkill_state(struct iwl_op_mode *op_mode, bool state)
iwl_mvm_set_rfkill_state(mvm);
- /* iwl_run_init_mvm_ucode is waiting for results, abort it */
- if (calibrating)
+ /* iwl_run_init_mvm_ucode is waiting for results, abort it. */
+ if (rfkill_safe_init_done)
iwl_abort_notification_waits(&mvm->notif_wait);
+ /*
+ * Don't ask the transport to stop the firmware. We'll do it
+ * after cfg80211 takes us down.
+ */
+ if (unified)
+ return false;
+
/*
* Stop the device if we run OPERATIONAL firmware or if we are in the
* middle of the calibrations.
*/
- return state && (mvm->fwrt.cur_fw_img != IWL_UCODE_INIT || calibrating);
+ return state && (mvm->fwrt.cur_fw_img != IWL_UCODE_INIT ||
+ rfkill_safe_init_done);
}
static void iwl_mvm_free_skb(struct iwl_op_mode *op_mode, struct sk_buff *skb)
diff --git a/drivers/net/wireless/intel/iwlwifi/pcie/internal.h b/drivers/net/wireless/intel/iwlwifi/pcie/internal.h
index b513037dc066..85973dd57234 100644
--- a/drivers/net/wireless/intel/iwlwifi/pcie/internal.h
+++ b/drivers/net/wireless/intel/iwlwifi/pcie/internal.h
@@ -928,7 +928,7 @@ static inline void iwl_enable_rfkill_int(struct iwl_trans *trans)
MSIX_HW_INT_CAUSES_REG_RF_KILL);
}
- if (trans->cfg->device_family == IWL_DEVICE_FAMILY_9000) {
+ if (trans->cfg->device_family >= IWL_DEVICE_FAMILY_9000) {
/*
* On 9000-series devices this bit isn't enabled by default, so
* when we power down the device we need set the bit to allow it
--
2.20.1
