Currently mac80211 do not support probe response template for
mesh point. When WMI_SERVICE_BEACON_OFFLOAD is enabled, host
driver tries to configure probe response template for mesh, but
it fails because the interface type is not NL80211_IFTYPE_AP but
NL80211_IFTYPE_MESH_POINT.
To avoid this failure, skip sending probe response template to
firmware for mesh point.
Tested HW: WCN3990/QCA6174/QCA9984
Signed-off-by: Surabhi Vishnoi <svishnoi@xxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath10k/mac.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index b73c23d..3eceb67 100644
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -1630,6 +1630,10 @@ static int ath10k_mac_setup_prb_tmpl(struct ath10k_vif *arvif)
if (arvif->vdev_type != WMI_VDEV_TYPE_AP)
return 0;
+ /* For mesh, probe response and beacon share the same template */
+ if (ieee80211_vif_is_mesh(vif))
+ return 0;
+
prb = ieee80211_proberesp_get(hw, vif);
if (!prb) {
ath10k_warn(ar, "failed to get probe resp template from mac80211\n");
--
1.9.1
