Search Linux Wireless

[PATCH v2 3/3] libertas_tf: get the MAC address before registering the device

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



The start() callback is too late for this: NetworkManager would already
have seen the hardware, thinking 00:00:00:00:00:00 is its permanent
address.

Signed-off-by: Lubomir Rintel <lkundrak@xxxxx>
Reviewed-by: Steve deRosier <derosier@xxxxxxxxxxxxxx>
---
 .../net/wireless/marvell/libertas_tf/main.c   | 57 ++++---------------
 1 file changed, 11 insertions(+), 46 deletions(-)

diff --git a/drivers/net/wireless/marvell/libertas_tf/main.c b/drivers/net/wireless/marvell/libertas_tf/main.c
index d8bf0a4071da..5799e9886d83 100644
--- a/drivers/net/wireless/marvell/libertas_tf/main.c
+++ b/drivers/net/wireless/marvell/libertas_tf/main.c
@@ -125,37 +125,6 @@ static void lbtf_cmd_work(struct work_struct *work)
 	lbtf_deb_leave(LBTF_DEB_CMD);
 }
 
-/**
- *  lbtf_setup_firmware: initialize firmware.
- *
- *  @priv    A pointer to struct lbtf_private structure
- *
- *  Returns: 0 on success.
- */
-static int lbtf_setup_firmware(struct lbtf_private *priv)
-{
-	int ret = -1;
-
-	lbtf_deb_enter(LBTF_DEB_FW);
-	/*
-	 * Read priv address from HW
-	 */
-	eth_broadcast_addr(priv->current_addr);
-	ret = lbtf_update_hw_spec(priv);
-	if (ret) {
-		ret = -1;
-		goto done;
-	}
-
-	lbtf_set_mac_control(priv);
-	lbtf_set_radio_control(priv);
-
-	ret = 0;
-done:
-	lbtf_deb_leave_args(LBTF_DEB_FW, "ret: %d", ret);
-	return ret;
-}
-
 /**
  *  This function handles the timeout of command sending.
  *  It will re-send the same command again.
@@ -289,30 +258,17 @@ static void lbtf_tx_work(struct work_struct *work)
 static int lbtf_op_start(struct ieee80211_hw *hw)
 {
 	struct lbtf_private *priv = hw->priv;
-	int ret = -1;
 
 	lbtf_deb_enter(LBTF_DEB_MACOPS);
 
-	/* poke the firmware */
 	priv->capability = WLAN_CAPABILITY_SHORT_PREAMBLE;
 	priv->radioon = RADIO_ON;
 	priv->mac_control = CMD_ACT_MAC_RX_ON | CMD_ACT_MAC_TX_ON;
-	ret = lbtf_setup_firmware(priv);
-	if (ret)
-		goto err_setup_firmware;
-
-	if ((priv->fwrelease < LBTF_FW_VER_MIN) ||
-	    (priv->fwrelease > LBTF_FW_VER_MAX)) {
-		ret = -1;
-		goto err_setup_firmware;
-	}
+	lbtf_set_mac_control(priv);
+	lbtf_set_radio_control(priv);
 
 	lbtf_deb_leave(LBTF_DEB_MACOPS);
 	return 0;
-
-err_setup_firmware:
-	lbtf_deb_leave_args(LBTF_DEB_MACOPS, "fw setup error; ret=%d", ret);
-	return ret;
 }
 
 static void lbtf_op_stop(struct ieee80211_hw *hw)
@@ -648,6 +604,15 @@ struct lbtf_private *lbtf_add_card(void *card, struct device *dmdev,
 		goto err_init_adapter;
 	}
 
+	eth_broadcast_addr(priv->current_addr);
+	if (lbtf_update_hw_spec(priv))
+		goto err_init_adapter;
+
+	if (priv->fwrelease < LBTF_FW_VER_MIN ||
+	    priv->fwrelease > LBTF_FW_VER_MAX) {
+		goto err_init_adapter;
+	}
+
 	/* The firmware seems to start with the radio enabled. Turn it
 	 * off before an actual mac80211 start callback is invoked.
 	 */
-- 
2.20.1




[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Wireless Regulations]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux