From: Yan-Hsuan Chuang <yhchuang@xxxxxxxxxxx> The module parameter is added to turn on/off lps support. And the default value is "N". It is because that lps is not compatible with bt-coexistence, WOW/PNO and the calibration routines for now. After trade lps support off against these functionalities, it is reasonable to set the parameter default to "N". Signed-off-by: Yan-Hsuan Chuang <yhchuang@xxxxxxxxxxx> --- drivers/net/wireless/realtek/rtw88/main.c | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-) diff --git a/drivers/net/wireless/realtek/rtw88/main.c b/drivers/net/wireless/realtek/rtw88/main.c index ef010dc..8a2ec8a 100644 --- a/drivers/net/wireless/realtek/rtw88/main.c +++ b/drivers/net/wireless/realtek/rtw88/main.c @@ -13,6 +13,10 @@ #include "efuse.h" #include "debug.h" +static bool rtw_fw_support_lps; +module_param_named(support_lps, rtw_fw_support_lps, bool, 0644); +MODULE_PARM_DESC(support_lps, "Set Y to enable LPS support"); + static struct ieee80211_channel rtw_channeltable_2g[] = { {.center_freq = 2412, .hw_value = 1,}, {.center_freq = 2417, .hw_value = 2,}, @@ -158,7 +162,8 @@ static void rtw_watch_dog_work(struct work_struct *work) * more than two stations associated to the AP, then we can not enter * lps, because fw does not handle the overlapped beacon interval */ - if (data.rtwvif && !data.active && data.assoc_cnt == 1) + if (rtw_fw_support_lps && + data.rtwvif && !data.active && data.assoc_cnt == 1) rtw_enter_lps(rtwdev, data.rtwvif); if (rtw_flag_check(rtwdev, RTW_FLAG_SCANNING)) -- 2.7.4