Since we implement beconing on USB now, similar interfaces should be
supported for USB as are for MMIO. Tested only for AP and IBSS modes.
Signed-off-by: Stanislaw Gruszka <sgruszka@xxxxxxxxxx>
---
v2: set VHT_IBSS, vht reates are supported in ibss.
.../net/wireless/mediatek/mt76/mt76x02_util.c | 23 ++++++++++---------
1 file changed, 12 insertions(+), 11 deletions(-)
diff --git a/drivers/net/wireless/mediatek/mt76/mt76x02_util.c b/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
index edc84699d621..7f3747d0791f 100644
--- a/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
+++ b/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
@@ -150,19 +150,8 @@ void mt76x02_init_device(struct mt76x02_dev *dev)
mt76x02_dfs_init_detector(dev);
wiphy->reg_notifier = mt76x02_regd_notifier;
- wiphy->iface_combinations = mt76x02_if_comb;
- wiphy->n_iface_combinations = ARRAY_SIZE(mt76x02_if_comb);
- wiphy->interface_modes =
- BIT(NL80211_IFTYPE_STATION) |
- BIT(NL80211_IFTYPE_AP) |
-#ifdef CONFIG_MAC80211_MESH
- BIT(NL80211_IFTYPE_MESH_POINT) |
-#endif
- BIT(NL80211_IFTYPE_ADHOC);
-
wiphy->flags |= WIPHY_FLAG_HAS_CHANNEL_SWITCH;
- wiphy_ext_feature_set(wiphy, NL80211_EXT_FEATURE_VHT_IBSS);
/* init led callbacks */
if (IS_ENABLED(CONFIG_MT76_LEDS)) {
@@ -172,6 +161,18 @@ void mt76x02_init_device(struct mt76x02_dev *dev)
}
}
+ wiphy->iface_combinations = mt76x02_if_comb;
+ wiphy->n_iface_combinations = ARRAY_SIZE(mt76x02_if_comb);
+ wiphy->interface_modes =
+ BIT(NL80211_IFTYPE_STATION) |
+ BIT(NL80211_IFTYPE_AP) |
+#ifdef CONFIG_MAC80211_MESH
+ BIT(NL80211_IFTYPE_MESH_POINT) |
+#endif
+ BIT(NL80211_IFTYPE_ADHOC);
+
+ wiphy_ext_feature_set(wiphy, NL80211_EXT_FEATURE_VHT_IBSS);
+
hw->sta_data_size = sizeof(struct mt76x02_sta);
hw->vif_data_size = sizeof(struct mt76x02_vif);
--
2.19.2
