On Tue, Jan 8, 2019 at 10:24 PM Kalle Valo <kvalo@xxxxxxxxxxxxxx> wrote: > > Siva Rebbagondla <siva8118@xxxxxxxxx> writes: > > > From: Prameela Rani Garnepudi <prameela.j04cs@xxxxxxxxx> > > > > With the current approach of scanning, roaming delays are observed. > > Firmware has support for back ground scanning. To get this advantage, > > mac80211 hardware scan is implemented, which decides type of scan to > > do based on connected state. > > > > When station is in not connected, driver returns with special value 1 > > to trigger software scan in mac80211. In case of connected state, > > background scan will be triggered. > > > > Signed-off-by: Prameela Rani Garnepudi <prameela.j04cs@xxxxxxxxx> > > Signed-off-by: Siva Rebbagondla <siva.rebbagondla@xxxxxxxxxxxxxxxxxx> > > --- > > changes in v4: renamed return value in hw_scan from "-EPERM" -> "1" [Jberg] > > changes in v3: replaced rsi_prepare_probe_request() with ieee80211_probereq_get() [Kvalo] > > changes in v2: none > > This depends on: > > e9da68ddea60 mac80211: allow hardware scan to fall back to software > > But that's in w-d-next now so this is safe to be apply. > > -- > Kalle Valo Yes Kvalo, you can apply this patch to w-d-next. Brgds, Siva Rebbagondla
