On Wed, Dec 05, 2018 at 08:06:33PM +0100, Alexander Wetzel wrote: > >On Sun, 2018-11-11 at 12:02 +0100, Alexander Wetzel wrote: > >>IEEE 802.11-2012 added support for Extended Key ID, allowing pairwise > >>keys to also use keyID 1 and moving group keys to IDs 2 and 3. > > > >Where do you read this? I've always been under the impression that > >individually and group addressed frames use key IDs from different > >"namespaces", so to speak, where PTK/STK can use 0 (0 or 1 with > >"Extended Key ID" support) and GTK can use 0-3. There is no such requirement to change group key IDs in the IEEE 802.11 standard when taking Extended Key ID mechanism into use. > >In fact, the per-frame pseudocode in 802.11-2016 12.9.2.6 clearly > >states: > > > >if MPDU has individual RA then > > lookup pairwise key using Key ID from MPDU > >else > > lookup group key using Key ID from MPDU > >endif > > > >If it weren't different namespaces, you'd not have to differentiate > >here. > > > > I was indeed struggling to understand what the intend of the standard is > here. I may well be wrong, but the note in "12.6.1.1.10 Mesh GTKSA" tipped > the scales to assume keyIDs are within one namespace only. > > "Since Key ID 0 is reserved for individually addressed frame transmission, > there are at most three available Key IDs (only two if extended Key IDs for > individually addressed frames are in use), and the different MGTKs would > contend for the single remaining Key ID upon rollover." Please note that this is is an informative note and not normative part of the standard. IMHO, that note is not accurate and it looks likely that it was added without full understanding on how the keys are used in the standard.. > I got the impression Extended Key IDs were added without updating all > sections which should get updates. But the pattern is suspect, even the igtk > numbers fit into the pattern: > > PTK 0 & 1 > GTK 1 & 2 & 3 > iGTK 4 & 5 An AP is allowed to do this, but there is no requirement for doing so. The pairwise key (TK, not PTK) is required to use Key ID 0 unless the optional Extended Key ID for Individually Addressed Frames capability is negotiated (and 0 or 1 if that capability is negotiated). Group keys (GTK) are allowed to use Key IDs 0..4. IGTKs are allowed to use Key ID values 4 and 5. There is a long history behind this and some de facto constraints due to that history and possible implementation constraints. However, as far as the protocol itself is concerned, there would be no real need for having IGTK use 4..5; it could have as well been 0..1 or 1..2 or whatever combination the AP would like to use. These three cases have completely independent namespaces for Key IDs as far as RSN is concerned with one exception: "Use group cipher suite" that was added as an option for some AP implementation that did not support individual key mapping. That special case would end up using GTK for both group-addressed and individually-addressed frames. That said, I'm not aware of there having ever been an actually deployed device with this constraint and even if there were, this mode is highly discouraged and should not be used for anything today. Anyway, this exception and similar implementation constraints are likely behind the expectations of TK and GTK having to use different Key ID values. As far as the kernel changes are concerned, cfg80211 and mac80211 should support everything that's allowed by the standard, i.e., use of Key IDs 0..3 for GTK. It is up to the user space implementation on the AP side (e.g., hostapd) to select which Key IDs are actually taken into use. -- Jouni Malinen PGP id EFC895FA
