From: Wright Feng <wright.feng@xxxxxxxxxxx>
APSTA can work on two band concurrently with using VSDB(Virtual
Simultaneous Dual-Band) or RSDB(Real Simultaneous Dual-Band) features.
In this case, we have to keep apsta is 1 in firmware side. However, if
we start wpa_supplicant on wlan0 and then start hostapd on wlan 1, the
apsta will be set to 0, and we will see data stall on wlan0(station)
So that, we only set apsta to 1 when AP start on primary interface.
Signed-off-by: Wright Feng <wright.feng@xxxxxxxxxxx>
Signed-off-by: Chi-Hsien Lin <chi-hsien.lin@xxxxxxxxxxx>
---
drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c | 4 +---
1 file changed, 1 insertion(+), 3 deletions(-)
diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
index 230a378c26fc..165ab1a3f943 100644
--- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
+++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
@@ -4513,9 +4513,7 @@ brcmf_cfg80211_start_ap(struct wiphy *wiphy, struct net_device *ndev,
}
}
- if ((dev_role == NL80211_IFTYPE_AP) &&
- ((ifp->ifidx == 0) ||
- !brcmf_feat_is_enabled(ifp, BRCMF_FEAT_RSDB))) {
+ if (dev_role == NL80211_IFTYPE_AP && ifp->ifidx == 0) {
err = brcmf_fil_cmd_int_set(ifp, BRCMF_C_DOWN, 1);
if (err < 0) {
brcmf_err("BRCMF_C_DOWN error %d\n", err);
--
2.1.0
