On 2018-10-31 14:11, Stanislaw Gruszka wrote:
> If we are associated and scanning is performed, sw_scan_complete callback
> is done after we get back to operating channel, so we do not perform
> queue cal work. Fix this queue cal work from sw_scan_complete().
>
> We have to restore gain in MT_BBP(AGC, 8) register after scanning, as
> it was multiple times modified by channel switch code. So queue cal work
> without any delay and reset dev->cal.low_gain to assure calibration
> code will AGC gain value.
>
> Note patch was not tested on mt76x2, but should work and be needed
> fix as well.
>
> Fixes: bbd10586f0df ("mt76x0: phy: do not run calibration during channel switch")
> Signed-off-by: Stanislaw Gruszka <sgruszka@xxxxxxxxxx>
> ---
> v1 -> v2:
> only queue cal work with 0 delay an reset dev->cal.low_gain
>
> drivers/net/wireless/mediatek/mt76/mt76x02_util.c | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/drivers/net/wireless/mediatek/mt76/mt76x02_util.c b/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
> index 9f083008dbd4..747fd2c9ec45 100644
> --- a/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
> +++ b/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
> @@ -553,6 +553,12 @@ void mt76x02_sw_scan_complete(struct ieee80211_hw *hw,
> clear_bit(MT76_SCANNING, &dev->mt76.state);
> if (mt76_is_mmio(dev))
> tasklet_enable(&dev->pre_tbtt_tasklet);
> +
> + if (vif->bss_conf.assoc) {
> + /* Restore AGC gain and resume calibration after scanning. */
> + dev->cal.low_gain = -1;
> + ieee80211_queue_delayed_work(hw, &dev->cal_work, 0);
> + }
I think checking vif->bss_conf.assoc here is not enough, since we might
be using multiple interfaces (e.g. AP+STA)
- Felix
