On 09/28/2018 12:47 PM, Rajkumar Manoharan wrote:
On 2018-09-28 08:25, Toke Høiland-Jørgensen wrote:
So this just uses the calculated airtime based on rate and size? Wasn't
there supposed to be an airtime usage value reported by the firmware? :)
Firmware interface changes are in progress. Airtime for sta/tid will be reported via
htt tx-compl and rx ind messages. Meantime I thought it would be useful to use Kan's changes
for ATF validation in ath10k using existing firmware. :)
Maybe you can get the firmware guys to report the tx rate in the tx-completion
(like I have been doing for years in my ath10k-ct firmware)? Then let the host
do the air-time calculating?
I'll give them firmware patches if the want :)
Thanks,
Ben
-Rajkumar
--
Ben Greear <greearb@xxxxxxxxxxxxxxx>
Candela Technologies Inc http://www.candelatech.com
