According to vendor sdk, vco calibration has to be executed for each channel configuration whereas mcu calibration has to be performed during channel scanning. This patch fixes the mt76x0 monitor mode issue since in that configuration vco calibration was never executed Fixes: 10de7a8b4ab9 ("mt76x0: phy files") Tested-by: Sid Hayn <sidhayn@xxxxxxxxx> Signed-off-by: Lorenzo Bianconi <lorenzo.bianconi@xxxxxxxxxx> --- drivers/net/wireless/mediatek/mt76/mt76x0/phy.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/wireless/mediatek/mt76/mt76x0/phy.c b/drivers/net/wireless/mediatek/mt76/mt76x0/phy.c index 5da7bfbe907f..14e8c575f6c3 100644 --- a/drivers/net/wireless/mediatek/mt76/mt76x0/phy.c +++ b/drivers/net/wireless/mediatek/mt76/mt76x0/phy.c @@ -757,10 +757,10 @@ __mt76x0_phy_set_channel(struct mt76x0_dev *dev, /* Vendor driver don't do it */ /* mt76x0_phy_set_tx_power(dev, channel, rf_bw_band); */ + mt76x0_vco_cal(dev, channel); if (scan) - mt76x0_vco_cal(dev, channel); + mt76x0_mcu_calibrate(dev, MCU_CAL_RXDCOC, 1); - mt76x0_mcu_calibrate(dev, MCU_CAL_RXDCOC, 1); mt76x0_phy_set_chan_pwr(dev, channel); dev->mt76.chandef = *chandef; -- 2.18.0