Search Linux Wireless

Re: [PATCH v3] ath10k: average ack rssi support for data frames

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 2018-09-04 17:49, Kalle Valo wrote:
Balaji Pothunoori <bpothuno@xxxxxxxxxxxxxx> writes:

Average ack rssi value is weighted average of ack rssi for
no of msdu's has been sent.
This feature is enabled by the host driver if firmware is capable.
After receiving event from host, firmware allocates the necessary
memory to store the ack_rssi for data packets during the init time.

After each successful transmission, If tx completion status is OK
and 24th bit is set in HTT message header then host will fetch the
ack_rssi else host can ignore the ack_rssi field

Signed-off-by: Balaji Pothunoori <bpothuno@xxxxxxxxxxxxxx>
---
v2:
   Addressed ath10k-check warnings
v3:
   cfg80211/mac80211 changes are already merged hence
   rebased ath10k patch alone.

Heh, we had a collision. Just 2 hours ago I rebased v2, fixed some
conflicts and it's now in pending branch:

https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=pending&id=ca376d236d335ccc9475ea1ab49df4643d8246b7

So please check that, and if it's good most likely I'll drop this v3.

Thanks kalle,
I am fine with the changes and you can ignore this v3.

Regards,
Balaji.



[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Wireless Regulations]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux