Hi Sid
On Wed, Aug 29, 2018 at 02:26:44AM +0000, Sid Hayn wrote:
> Thanks for working on this, I have a small stack of different devices
> covered by this driver which I'm excited to test with.
>
> I'm running wireless-testing which may or may not be fully up to date
> on the patches you have sent (head is at
> c9cd161770dd1866207b70d41ec03c9a26eea94f from Aug 13th), so please
> tell me if this has already been fixed. I have a script that attempts
> to connect to 16 differently configured SSIDs using 33 different (yet
> compatible) wpa_supplicant.conf files and reports failures to me.
> It's hardly perfect, but it gives me an idea if something is obviously
> broken and needs a deeper dive. When I run this script against a
> device supported by mt76x2 or mt76x0 I get an unusual error.
> Everything goes fine, connect, dhcp, disconnect, connect, dhcp,
> disconnect, but after about 5 or 6 connections I start getting errors
> like this during wpa_supplicant:
>
> Could not set interface t2uh flags (UP): No space left on device
> nl80211: Could not set interface 't2uh' UP
> nl80211: deinit ifname=t2uh disabled_11b_rates=0
> t2uh: Failed to initialize driver interface
>
> and then this with dhcpcd:
>
> dhcpcd_prestartinterface: t2uh: No space left on device
> t2uh: waiting for carrier
>
> the same happens with just ifconfig up:
>
> SIOCSIFFLAGS: No space left on device
This looks like some memory leak, not sure where, but it quite probable
that is in the m76x{0,2} driver. You can check periodically using 'free'
command (or in more details by 'cat /proc/meminfo') if memory is
leaking. Then compile kernel with CONFIG_DEBUG_KMEMLEAK to see where
the leak happen.
Regards
Stanislaw
