I wrote: > I guess the conservative approach is to just use sc->led_on = 1 in the > VENDOR_ID_COMPAQ branch ...here's the obvious patch for this, let me know if it works for you. Subject: [PATCH] ath5k: use positive logic for HP laptop LEDs Helge Deller reports that HP laptops (NC4010 and NC6000) use active- high signals to turn on the LEDs. Previous code used active-low for all devices. Signed-off-by: Bob Copeland <me@xxxxxxxxxxxxxxx> --- drivers/net/wireless/ath5k/base.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/wireless/ath5k/base.c b/drivers/net/wireless/ath5k/base.c index a43e9b2..fb6fd14 100644 --- a/drivers/net/wireless/ath5k/base.c +++ b/drivers/net/wireless/ath5k/base.c @@ -2551,8 +2551,6 @@ ath5k_init_leds(struct ath5k_softc *sc) struct pci_dev *pdev = sc->pdev; char name[ATH5K_LED_MAX_NAME_LEN + 1]; - sc->led_on = 0; /* active low */ - /* * Auto-enable soft led processing for IBM cards and for * 5211 minipci cards. @@ -2561,11 +2559,13 @@ ath5k_init_leds(struct ath5k_softc *sc) pdev->device == PCI_DEVICE_ID_ATHEROS_AR5211) { __set_bit(ATH_STAT_LEDSOFT, sc->status); sc->led_pin = 0; + sc->led_on = 0; /* active low */ } /* Enable softled on PIN1 on HP Compaq nc6xx, nc4000 & nx5000 laptops */ if (pdev->subsystem_vendor == PCI_VENDOR_ID_COMPAQ) { __set_bit(ATH_STAT_LEDSOFT, sc->status); sc->led_pin = 1; + sc->led_on = 1; /* active high */ } if (!test_bit(ATH_STAT_LEDSOFT, sc->status)) goto out; -- 1.5.4.2.182.gb3092 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html