Hi, I'm not able to load rt2500pci from 2.6.26-rc9 under Gentoo. This card currently works under Debian Etch with 2.6.18 kernel and rt2500-source 1.1.0+cvs20060620-3. lspci -vvvv Network controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01) Subsystem: RaLink Unknown device 2560 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR+ FastB2B- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 64, Cache Line Size: 64 bytes Interrupt: pin A routed to IRQ 185 Region 0: Memory at fba00000 (32-bit, non-prefetchable) [size=8K] Capabilities: [40] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME- dmesg 2.6.18 PCI: Enabling device 0000:00:0c.0 (0110 -> 0112) ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 17 (level, low) -> IRQ 185 rt2500 1.1.0 CVS 2005/07/10 http://rt2x00.serialmonkey.com dmesg 2.6.26-rc9 ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 17 (level, low) -> IRQ 17 phy0: Selected rate control algorithm 'pid' phy0: Failed to initialize wep phy0 -> rt2x00lib_probe_dev: Error - Failed to initialize hw. rt2500pci: probe of 0000:00:0c.0 failed with error -12 .config 2.6.18 precompiled Kernel from Debian .config 2.6.26-rc9 <http://www-user.tu-chemnitz.de/~stefb/rt2500pci/config> Next I'm going to test 2.6.24 and 2.6.25 to check whether it's an regression or not. Regards, Stefan -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
