When finishing scanning we switch to operational channel sill with SCANNING flag. This mean that we never perform calibration works after scanning. To fix the problem queue calibration works on .sw_scan_complete() routine. Signed-off-by: Stanislaw Gruszka <sgruszka@xxxxxxxxxx> --- drivers/net/wireless/mediatek/mt7601u/main.c | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/drivers/net/wireless/mediatek/mt7601u/main.c b/drivers/net/wireless/mediatek/mt7601u/main.c index 43ebd460ba86..f2ddefaa29f7 100644 --- a/drivers/net/wireless/mediatek/mt7601u/main.c +++ b/drivers/net/wireless/mediatek/mt7601u/main.c @@ -285,6 +285,12 @@ static int mt7601u_config(struct ieee80211_hw *hw, u32 changed) mt7601u_agc_restore(dev); clear_bit(MT7601U_STATE_SCANNING, &dev->state); + + ieee80211_queue_delayed_work(dev->hw, &dev->cal_work, + MT_CALIBRATE_INTERVAL); + if (dev->freq_cal.enabled) + ieee80211_queue_delayed_work(dev->hw, &dev->freq_cal.work, + MT_FREQ_CAL_INIT_DELAY); } static int -- 1.9.3
