From: Ping-Ke Shih <pkshih@xxxxxxxxxxx> If there is no connection, driver will enter IPS state. Meanwhile, it fails to scan channel 1 by the command 'iw dev wlan0 scan freq 2412', because hardware channel setting lose after IPS. Thus, restore channel setting from hw->conf.channel set by last rtl_op_config(). Signed-off-by: Tim Lee <timlee@xxxxxxxxxxx> --- drivers/net/wireless/realtek/rtlwifi/ps.c | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/drivers/net/wireless/realtek/rtlwifi/ps.c b/drivers/net/wireless/realtek/rtlwifi/ps.c index 6a4008845f49..0ffe43772c9a 100644 --- a/drivers/net/wireless/realtek/rtlwifi/ps.c +++ b/drivers/net/wireless/realtek/rtlwifi/ps.c @@ -51,6 +51,12 @@ bool rtl_ps_enable_nic(struct ieee80211_hw *hw) &rtlmac->retry_long); RT_CLEAR_PS_LEVEL(ppsc, RT_RF_OFF_LEVL_HALT_NIC); + /*<2.1> Switch Channel & Bandwidth to last rtl_op_config setting*/ + rtlpriv->cfg->ops->switch_channel(hw); + rtlpriv->cfg->ops->set_channel_access(hw); + rtlpriv->cfg->ops->set_bw_mode(hw, + cfg80211_get_chandef_type(&hw->conf.chandef)); + /*<3> Enable Interrupt */ rtlpriv->cfg->ops->enable_interrupt(hw); -- 2.15.1
