On Mon, Nov 06, 2017 at 11:59:37AM +0100, Arend van Spriel wrote: > On 11/4/2017 2:24 PM, Simon Shields wrote: > > Some boards use an external 32khz clock for low-power > > mode timing. Make sure the clock is powered on while the chipset > > is active. > > Do you have such a board? With the little documentation I can get my hands > on here I wonder whether the clock needs to be enabled before the device is > powered. If you have the hardware I would like to check some registers in > the device. > Yes. Trats2 (exynos4412-based) has such a setup. The BCM4334 works fine with this patch and one more that enables the WL_REG_EN pin when brcmfmac is probed. Without this patch (and only enabling WL_REG_EN), the chip is detected but attempting to initialise it fails with a bunch of timeouts. > Regards, > Arend Cheers, Simon
