Hi Im trying to get wds working. I haven’t found much documentation on this topic. This is what i have found: https://wireless.wiki.kernel.org/en/users/documentation/iw#setting_up_a_wds_peer I have configured two machines with hostapd with the same config. Its also the same wifi card WLE200NX using the AR9280 chipset. After APs is running I have used this commands on both AP’s with the other APs wifi mac address: iw phy phy0 interface add wds0 type wds iw dev wds0 set peer <MAC address> then wds0 interface is showing up ------------------ wds0 IEEE 802.11abgn Mode:Repeater Access Point: Not-Associated Tx-Power=20 dBm Retry short limit:7 RTS thr:off Fragment thr:off Power Management:off --------------------- But it says Access Point: Not-Associated I have no clue what to do next. Is there anyone who know something about this? Thank you for any help Best Regards, Håvard Rabbe
