From: Ilan Peer <ilan.peer@xxxxxxxxx> The code did not consider the case that the channel switch counter is <= 1, which would result with an inaccurate calculation of the time event apply time. As the specification states that in case of counter == 0 the switch occurs at any time after the reception the frame, and for counter == 1 the switch would happens before the next TBTT, schedule the time event immediately. Signed-off-by: Ilan Peer <ilan.peer@xxxxxxxxx> Signed-off-by: Luca Coelho <luciano.coelho@xxxxxxxxx> --- drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c | 13 +++++++++---- 1 file changed, 9 insertions(+), 4 deletions(-) diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c b/drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c index 01143c491e53..cfabe302c9c7 100644 --- a/drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c +++ b/drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c @@ -3875,11 +3875,16 @@ static int iwl_mvm_pre_channel_switch(struct ieee80211_hw *hw, /* Schedule the time event to a bit before beacon 1, * to make sure we're in the new channel when the - * GO/AP arrives. + * GO/AP arrives. In case count <= 1 immediately schedule the + * TE (this might result with some packet loss or connection + * loss). */ - apply_time = chsw->device_timestamp + - ((vif->bss_conf.beacon_int * (chsw->count - 1) - - IWL_MVM_CHANNEL_SWITCH_TIME_CLIENT) * 1024); + if (chsw->count <= 1) + apply_time = 0; + else + apply_time = chsw->device_timestamp + + ((vif->bss_conf.beacon_int * (chsw->count - 1) - + IWL_MVM_CHANNEL_SWITCH_TIME_CLIENT) * 1024); if (chsw->block_tx) iwl_mvm_csa_client_absent(mvm, vif); -- 2.14.1
