Dan Williams <dcbw@xxxxxxxxxx> wrote: [...] >You'll probably say "aim for the 75% case" or something like that, >which is fine, but then you're depending on your 75% case to be (a) >single AP, (b) never move (eg, only bond wifi + ethernet), (c) little >radio interference. I'm not sure I'd buy that. If I've put words in >your mouth, forgive me. The primary use case that I'm aware of for bonding with wireless devices is in active-backup mode, paired with an ethernet adapter set as the bonding "primary" device. I think this is the case that absolutely should just work. I don't think bonding cares (or should care) about (a) - (c) for this use. Your point (b) suggests that there are use cases other than the above; I'm unfamiliar with any use other than wifi + ethernet, can you elaborate? -J --- -Jay Vosburgh, jay.vosburgh@xxxxxxxxxxxxx
