On Fri, Jul 28, 2017 at 09:50:21PM +0200, Arend van Spriel wrote: > On 28-07-17 19:49, Russell King - ARM Linux wrote: > > Replacing that "(!mbss)" with "mbss" results in AP mode working on the > > 4330. However, I suspect: > > > > if (brcmf_feat_is_enabled(ifp, BRCMF_FEAT_MBSS)) > > brcmf_fil_iovar_int_set(ifp, "mbss", mbss); > > > > actually makes much more sense. > > > > Given that this is direct firmware interaction, I can't say which is > > correct - all I can say is that mainline kernels are currently broken. > > Indeed. I have to come up with a proper fix for both scenarios. Thanks > for the report. I'm now on 4.13-rc4, and running with my patch. I've configured AP mode: Interface wlan0 ifindex 3 wdev 0x1 addr 6c:ad:f8:1d:4c:d9 ssid Time type AP wiphy 0 channel 5 (2432 MHz), width: 20 MHz, center1: 2432 MHz using NetworkManager with a WPA2 key. However, a Realtek RTL8192EU client is trying to connect to it, but is unable: [ 1750.497436] wlan0: authenticate with 6c:ad:f8:1d:4c:d9 [ 1750.530929] wlan0: send auth to 6c:ad:f8:1d:4c:d9 (try 1/3) [ 1750.738795] wlan0: send auth to 6c:ad:f8:1d:4c:d9 (try 2/3) [ 1750.946780] wlan0: send auth to 6c:ad:f8:1d:4c:d9 (try 3/3) [ 1751.154764] wlan0: authentication with 6c:ad:f8:1d:4c:d9 timed out The antennas are definitely within range (finger to thumb distance) and the Realtek can definitely see the BCM4330 in AP mode. I don't see the interrupts for the SDIO interface increment while the client tries to connect. The WPA2 password is definitely the same on both ends. Any ideas how to debug this? Thanks. -- RMK's Patch system: http://www.armlinux.org.uk/developer/patches/ FTTC broadband for 0.8mile line in suburbia: sync at 8.8Mbps down 630kbps up According to speedtest.net: 8.21Mbps down 510kbps up
