* Ingo Molnar <mingo@xxxxxxx> wrote: > > Subject: clean up and comment local_bh_enable code > > > > There's no need to use local_irq_save() over local_irq_disable() in > > the local_bh_enable code since it is a bug to call it with irqs > > disabled and do_softirq will enable irqs if there is any pending > > work. Consolidate the code from local_bh_enable and ..._ip to avoid > > having a disconnect between them in the warnings they trigger that > > is currently there. Also always trigger the warning on in_irq(), not > > just in the trace-irqflags case. > > applied to tip/core/softirq for testing, thanks Johannes. ok, -tip testing found that your patch triggers a new warning on an old testbox that uses 3c59x vortex and netlogging: -----> calling vortex_init+0x0/0xb0 PCI: Found IRQ 10 for device 0000:00:0b.0 PCI: Sharing IRQ 10 with 0000:00:0a.0 PCI: Sharing IRQ 10 with 0000:00:0b.1 3c59x: Donald Becker and others. 0000:00:0b.0: 3Com PCI 3c556 Laptop Tornado at e0800400. PCI: Enabling bus mastering for device 0000:00:0b.0 initcall vortex_init+0x0/0xb0 returned 0 after 47 msecs ... calling init_netconsole+0x0/0x1b0 netconsole: local port 4444 netconsole: local IP 10.0.1.9 netconsole: interface eth0 netconsole: remote port 4444 netconsole: remote IP 10.0.1.16 netconsole: remote ethernet address 00:19:xx:xx:xx:xx netconsole: device eth0 not up yet, forcing it eth0: setting half-duplex. eth0: setting full-duplex. ------------[ cut here ]------------ WARNING: at kernel/softirq.c:137 local_bh_enable_ip+0xd1/0xe0() Pid: 1, comm: swapper Not tainted 2.6.26-rc6-tip #2091 [<c0125ecf>] warn_on_slowpath+0x4f/0x70 [<c0126834>] ? release_console_sem+0x1b4/0x1d0 [<c0126d00>] ? vprintk+0x2a0/0x450 [<c012fde5>] ? __mod_timer+0xa5/0xc0 [<c046f7fd>] ? mdio_sync+0x3d/0x50 [<c0160ef6>] ? marker_probe_cb+0x46/0xa0 [<c0126ed7>] ? printk+0x27/0x50 [<c046f4c3>] ? vortex_set_duplex+0x43/0xc0 [<c046f521>] ? vortex_set_duplex+0xa1/0xc0 [<c0471b92>] ? vortex_timer+0xe2/0x3e0 [<c012b361>] local_bh_enable_ip+0xd1/0xe0 [<c08d9f9f>] _spin_unlock_bh+0x2f/0x40 [<c0471b92>] vortex_timer+0xe2/0x3e0 [<c014743b>] ? trace_hardirqs_on+0xb/0x10 [<c0147358>] ? trace_hardirqs_on_caller+0x88/0x160 [<c012f8b2>] run_timer_softirq+0x162/0x1c0 [<c0471ab0>] ? vortex_timer+0x0/0x3e0 [<c012b361>] local_bh_enable_ip+0xd1/0xe0 [<c08d9f9f>] _spin_unlock_bh+0x2f/0x40 [<c0471b92>] vortex_timer+0xe2/0x3e0 [<c014743b>] ? trace_hardirqs_on+0xb/0x10 [<c0147358>] ? trace_hardirqs_on_caller+0x88/0x160 [<c012f8b2>] run_timer_softirq+0x162/0x1c0 [<c0471ab0>] ? vortex_timer+0x0/0x3e0 [<c0471ab0>] ? vortex_timer+0x0/0x3e0 [<c012b60a>] __do_softirq+0x9a/0x160 [<c012b570>] ? __do_softirq+0x0/0x160 [<c0106775>] call_on_stack+0x15/0x30 [<c012b4f5>] ? irq_exit+0x55/0x60 [<c0106e85>] ? do_IRQ+0x85/0xd0 [<c0147391>] ? trace_hardirqs_on_caller+0xc1/0x160 [<c0104888>] ? common_interrupt+0x28/0x30 [<c08d8ac8>] ? mutex_unlock+0x8/0x10 [<c08d8180>] ? _cond_resched+0x10/0x30 [<c07a3be7>] ? netpoll_setup+0x117/0x390 [<c0cbfcfe>] ? init_netconsole+0x14e/0x1b0 [<c013d539>] ? ktime_get+0x19/0x40 [<c0c9bab2>] ? kernel_init+0x1b2/0x2c0 [<c0cbfbb0>] ? init_netconsole+0x0/0x1b0 [<c0396aa4>] ? trace_hardirqs_on_thunk+0xc/0x10 [<c0103f12>] ? restore_nocheck_notrace+0x0/0xe [<c0c9b900>] ? kernel_init+0x0/0x2c0 [<c0c9b900>] ? kernel_init+0x0/0x2c0 [<c0104aa7>] ? kernel_thread_helper+0x7/0x10 ======================= ---[ end trace 37f9c502aff112e0 ]--- console [netcon0] enabled netconsole: network logging started initcall init_netconsole+0x0/0x1b0 returned 0 after 2914 msecs real bug or false positive? config is at: http://redhat.com/~mingo/misc/config-Fri_Jun_20_16_51_07_CEST_2008.bad Ingo -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
