The num_different_channels in wiphy info is not correct when firmware
supports mchan. When mchan is on, num_different_channels is always
overridden to 1 in brcmf_setup_ifmodes. Correct the logic by moving
num_different_channels setting forward.
Signed-off-by: Wright Feng <wright.feng@xxxxxxxxxxx>
---
drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
index 54588d2..3dcb139 100644
--- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
+++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
@@ -6318,6 +6318,8 @@ static int brcmf_setup_ifmodes(struct wiphy *wiphy, struct brcmf_if *ifp)
if (p2p) {
if (brcmf_feat_is_enabled(ifp, BRCMF_FEAT_MCHAN))
combo[c].num_different_channels = 2;
+ else
+ combo[c].num_different_channels = 1;
wiphy->interface_modes |= BIT(NL80211_IFTYPE_P2P_CLIENT) |
BIT(NL80211_IFTYPE_P2P_GO) |
BIT(NL80211_IFTYPE_P2P_DEVICE);
@@ -6327,10 +6329,10 @@ static int brcmf_setup_ifmodes(struct wiphy *wiphy, struct brcmf_if *ifp)
c0_limits[i++].types = BIT(NL80211_IFTYPE_P2P_CLIENT) |
BIT(NL80211_IFTYPE_P2P_GO);
} else {
+ combo[c].num_different_channels = 1;
c0_limits[i].max = 1;
c0_limits[i++].types = BIT(NL80211_IFTYPE_AP);
}
- combo[c].num_different_channels = 1;
combo[c].max_interfaces = i;
combo[c].n_limits = i;
combo[c].limits = c0_limits;
--
1.9.1
