Matthias Frei <mf@frei.media> writes: > Set the a-mpdu reference number in ath10k to make it accessible in the receivers radiotap header. Implemented as in ath9k. > The reference number is needed for troubleshooting and research at the receivers site (e.g. to identify mpdu's that were aggregated in an a-mpdu) > > Signed-off-by: Matthias Frei <mf@frei.media> I did some changes in pending branch, please review them: https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=pending&id=f722728460a5c9e9200a7f1362fa605a714c1968 > --- a/drivers/net/wireless/ath/ath10k/core.h > +++ b/drivers/net/wireless/ath/ath10k/core.h > @@ -989,6 +989,9 @@ struct ath10k { > u32 reg_ack_cts_timeout_orig; > } fw_coverage; > > + /* AMPDU */ > + u32 ampdu_ref; The comment is not providing any extra value, I'll remove that. What about locking? How is this protected or doesn't it need anything? Also I renamed this to ampdu_reference just to be consistent with the mac80211 name. > --- a/drivers/net/wireless/ath/ath10k/htt_rx.c > +++ b/drivers/net/wireless/ath/ath10k/htt_rx.c > @@ -877,16 +877,24 @@ static void ath10k_htt_rx_h_ppdu(struct ath10k *ar, > status->nss = 0; > status->encoding = RX_ENC_LEGACY; > status->bw = RATE_INFO_BW_20; > - status->flag &= ~RX_FLAG_MACTIME_END; > - status->flag |= RX_FLAG_NO_SIGNAL_VAL; > + status->flag &= ~(RX_FLAG_MACTIME_END | RX_FLAG_AMPDU_IS_LAST); > + status->flag |= RX_FLAG_NO_SIGNAL_VAL | RX_FLAG_AMPDU_DETAILS | RX_FLAG_AMPDU_LAST_KNOWN; This added a new warning: drivers/net/wireless/ath/ath10k/htt_rx.c:894: line over 90 characters I fixed that by separating the setting of ampdu flags. > + /* set ampdu ref */ > + status->ampdu_reference = ar->ampdu_ref; The comment is not telling anything new so removed it. > - if (is_last_ppdu) > + if (is_last_ppdu) { > ath10k_htt_rx_h_mactime(ar, status, rxd); > + > + /* set ampdu last segment flag */ > + status->flag |= RX_FLAG_AMPDU_IS_LAST; > + ar->ampdu_ref++; > + } So this counter is per wiphy, not per vdev. Is that ok? -- Kalle Valo